I going to need some strange pulley arrangement.
The stepper motor has a 8 mm (.315") shaft.
The leadscrew has a 19.5mm (3/4") shaft.
Of course my big lathe is in pieces so I might be challenged if I need to bore a pulley
but if I could get 2 matched blank pulleys I could bore them on my mill so boring is not out of the question.
So anyone have suggestions? Anyone know of blank pulleys?
Ralph
On Tue, Feb 4, 2020 at 7:46 PM Ralph Hulslander via Groups.Io <rhulslander=
[email protected]> wrote:
I cut a 5x piece of angle iron and made up a base plate:?
It actually looks good, now I need to cut a slot to fasten the motor down and find some pulleys.
Then come up with? some buttons for motor control, so I also will need help with the programming.
Now where do I find belts and pulleys?
Ralph
Clausing 8520, Craftsman 12x36 Lathe, 4x12 mini lathe, 14" Delta drill press, 40 watt laser, Consew brushless DC motors and a non working 3D printer
--
Clausing 8520, Craftsman 12x36 Lathe, 4x12 mini lathe, 14" Delta drill press, 40 watt laser, Consew brushless DC motors and a non working 3D printer
