¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Digitalhobbyist
  2. Messages
Single Messages Topics Expanded Polls
 



---------- Forwarded message ---------
From: John Lindo <bechetboat@...>
Date: Thu, 8 Apr 2021 at 18:31
Subject: Re: [digitalhobbyist] Swing up tool holder files #MISC #MODS #LATHES #file-notice
To: <[email protected]>


Good question. Charlie

The?drawing shows a pin on the swinging?arm and in the block there is a accurately?positioned slot.
It used to be the thrust stop when cutting left hand threads, IE The tool going away from the chuck, this?early design
reduced the bending forces being applied on the bearing pin.
This was my first approach before I modified to add on the thrust plate. Now the pin/ slot are optional
or use this method and not?use?the thrust plate. You do not need both designs.?
I left?it in on my original drawings, also this pin is visible in some of the recent photos sent to the forum.

Thanks for your interest.

John



On Thu, 8 Apr 2021 at 14:56, CLevinski <clevinski@...> wrote:
John,

What is the purpose of the two "Optional Rods" shown in the "Swinging Tool Holder External.pdf" file?
--
Regards,

Charlie
New Jersey, USA

SATTINGER¡¯S LAW: It works better if you plug it in.
EDWARD'S LAW: It works even better if you turn it on.


--
John
Join [email protected] to automatically receive all group messages.