At least LMS are usually really good?and helpful to talk to.
Ralph
On Thu, Apr 1, 2021 at 10:03 AM, Bill in OKC too wrote:
I'd talk check it again, and either talk to them about it, or return it. M40-1.5 is the standard for ER32 chucks. At least according to the Rego-fix documentation I have. See attached.
Hi, Bill,
Thanks for the documentation, Bill. I have saved it for future use. The thread spec is clearly shown on page 13-1. Rego-Fix are, as I understand it, the original developers of the ER collet system. I believe that the "R" in "ER" stands for "Rego-Fix".
I have emailed LMS about it, asking if they sell an M40-1.0 ER-32 collet nut and asking what they propose otherwise.
I did make sure that it wasn't my aging eyes; a thread gauge says it's 1.0 mm pitch, plus a visual comparison is pretty clear.
?
--
Regards,
Charlie
New Jersey, USA
SATTINGER¡¯S LAW: It works better if you plug it in.
--
Clausing 8520, Craftsman 12x36 Lathe, 4x12 mini lathe, 14" Delta drill press, 40 watt laser, Consew brushless DC motors and a non working 3D printer
