开云体育

That might be touchy for one of the wide coverage repeaters in the Atlanta area, but I have already done that on WD4STR C in Lawrenceville. I'm guessing you would want one you could hit for

John, I've asked this before, but don't remember the answer. Would it be acceptable to link one of the VHF or UHF repeaters to REF030D for a period of time to test D-RATS over RF? Or, is that

Rusty: You are welcome to use REF030D for D-RATS. That is our preferred reflector module for data in Georgia. You will usually find some stations there on D-RATS. John WB4QDX Sent: Thursday,

Are there any popular reflectors that I could connect to so I can play around with RF DRATS?? Rusty Bryant WB4BSD Sent from my iPhone 4S

Here are a few I have used with varying degrees of success. The RSS and CAP messages seem to be truncated after a certain amount of characters.

Turn off the power save feature in both of the radios. Go to D-RATS preferences and make these changes: Under Transfers, enable "Remote File Transfers". Set Warmup Length to 16. Set Warmup Timeout

Hello All: Thanks to the helpful responses, I now have the 91AD and 92AD working as the radio part of a Drats node. As some folks had noted, baud rate was the issue and at 38K baud both HT Dstar

I have been trying to get a QST message using the CAP feed working with no luck so far. Has anyone got a CAP feed message working they would share as an example? An RSS example too? I have been

Jeff,It sounds to me as if you are running two computers each with their own radio in the same room. Here are a few suggestions: Uncheck the raw text box as it is not needed with D-RATS to D-RATS

try and uncheck the raw and sniffer and check mark in the connect to internet under the file pull down menu. 73

Which radios? And do you have the radios listed in Email Access? -- 73 de N4VIP (SFARES EC, Santa Fe and San Miguel Counties DEC), Don

Hello Mike and Group: Thanks for the follow-up: 1. Do the radios transmit when D-RATS sends data? *** Yes - tx and observed reception by the target radio. 2. Does the receiving radio

Hi Jeff, Some questions that may help us understand what is happening: 1. Do the radios transmit when D-RATS sends data? 2. Does the receiving radio display the call sign and message from the

The one question I have is, is it set for serial and not network? AL KF5SMH

Hello All: I am trying to run DRATS radio -to- radio, with Internet and Ratflectord disabled. Radio setup for com port and baud, and port <=> radio tested via programming as OK. Raw and

Patrick (N3TSZ) Get 100% soon Buddy! + agree on the Packet, DRats DStar bridge, es Ecomm. de Hurb W1DOG Sent: Saturday, February 01, 2014 1:41 PM To: d-rats_group@... Subject: Re:

Glad to hear you are doing better Pat.

Hope you get totally over this soon. I have downloaded files from you in the past, but haven't played with DRATS in a long time. Your files are helpful. 73, Tom KC9ONY

Hello, I just took a look on my pi my ratflector is installed as root user. The file is located /root/.d-rats/repeater.config on another pi ratflector installed as user pi

fantastic...