开云体育

Once it tries to connect it will prompt you for the username and password in a separate box.

Should have been a bit less ambiguous here. When running an iPad as Xpanel using the Teal play button or F11, there does not appear to be any way to enter the un & pw. Simpy a checkbox to enable

Hve you checked/are you explicitly setting the level analog? I'm in transit right now but I seem to remember the level if not set programmatically could reset itself after a FW upgrade. Get Outlook

The Down-mixed analog 2-channel output.

FWIW, "Save As" operations in standard SimplWindows have been taking a looooong time for me recently as well. Often, I have to right-click close SW and reopen it. The file has been saved, but SW is

I didn't write the D3Pro program, but I occasionally need to add things to the RSD that were missed by the original programmer, or fix feedback issues, etc. I'm aware that re-writing it in Simpl is a

Hi of course. If Crestron and hvac is on the same subnet. Just check the port restrictions on switch. If hvac is on different subnet. You can use BBMD. Check True blue support. It’s nice

Service is online again.

Hi, What do we need to initialize connection between crestron and HVAC system over BACnet ? are they able to communicate to each other directly ?

so autodiscovery query only retrieves other Crestron devices on the network and doesn't retrieve local IP info. Would I use ipconfig to gather info for local processor?

1. My sources have told me that D3 is still a 'Live' product, though clearly It has ceased at least for the time being to get much-needed love (Home is their new girlfriend...) 2. Are you using

FYI, Weather Status OLH was updated: Answer ID: 1001127 " Due to a recent Microsoft IoT hub update, the Crestron Weather Service has been adversely impacted. Crestron Engineering and Microsoft are

Do you mean the Down-mixed analog 2-channel output? or the Dante Stream?

Good morning all, I ran a newer firmware update for an NVX 351c setup to v.6.0.4835.00027 and we noticed the extracted audio is significantly lower. The only change to the system was the update on

Thanks Michael.

Hi Brad, you can run console command "autodiscovery query" and filter then for the e.g. CP4 or whatever processors you are using. Hope it helps Michael Brad Wykoff via groups.io

Is there a way to use a command in Simpl# that allows for the same program into several processors, that on System Initialization() will get all other processors IP's on the same VLAN to set EISC

I understand the principle idea, I just don't do S+ to implement in reality. Found an example and created the S+ module.? Thanks for pointing me in that direction

Great Info!, Thanks Rick W! Signed, A former Village Person...

Did they really cease development or has their just not been any updates in the last little while? The last update is from October of 2020.