开云体育

Hi All, We're working on a church project and need a couple *reasonably priced* 4K projectors that have 8-10,000 lumens. Any suggestions? TIA!!

Hi, I'm looking for the way to control PTZ Hikvision cameras. Could you share the code which uses SimplSharpOnvifInterface.dll? Many thanks.

1. What is the reason that you're looking to use a Control subnet? 2. you can use a reasonably inexpensive router to set up the same configuration via VLans, one for the processor and one for the

Is there some particular reason you have to have the control subnet?

Hello, this is my first time setting this up, and it works great except the Lights page, for some reason it will not populate, the module is straight forward and i dont see any troubbleshooting that i

Hey everyone, My company is in the middle of a project in NYC and need a programmer who is experienced with C#.? Can anyone point me in the right direction?? This project is very time-sensitive.?

Yes you are right. The more I read about the AP4, the more I have no solution to this control subnet port mapping. Now I'm lost with what to do next, sigh.

You’re going to find this tough as the DIN-AP4 processor doesn’t have a Control Subnet physical interface or internal router. I’m guessing the AP4 is a substitute for a CP4N? I think a design

G'day all, Has anyone successfully added or modified a program file on a VC4 using curl and the REST API from a command line? I've tried but have been unable to make it work. I can query the existing

I'm using an AP4 processor and a program needs to configure the processer with a control subnet. The port map on the control subnet requires 2 ports: External 3072 to internal 3072 and the control

Wondering if anyone has an IR file for one of these units?

Yes, Lincoln is correct.? You want to use the? "uprogcmd" symbol.? Not the "console" symbol as I incorrectly stated.? That's what I get by doing thing from memory rather than looking at what I

You could route the output of the UCMD symbol to a SIO – you could then match something like “PROJON” (without the quotes) in the SIO and the corresponding digital would go high when you sent

Tim's code from Masters 2022 MSS-431 has a VirtualConsole class suited to this purpose. You can telnet in and even have it re-print the previous debug messages. You can find it linked from his

You most certainly can use the USRPROGCMD command to send serial data out of the RMC comport with a little bit of SIMPL and/or SIMPL+.? I use USERPROGCMD all the time to check the status of of

Thanks for answering, I was pretty sure by now that it wasn't possible. I have a few goals. One, was a simple curiosity what/how much can be accomplished from my VPN, without having my Windows VM

AFAIK, there isn’t a way to access a serial port on an endpoint in that way – passto /passthru have been historically used to access the console of devices (and in a very modal method – e.g.

Get a Niles APC-2 from eBay, plug the projector into the "Current Sensing" outlet, and use the 12v output or relay output to drive the projector lift.

Thanks John. At this point, no Crestron control, just manual. AV Receiver trigger controls lift (old Panasonic projector melted from being sent up too early from AV Receiver trigger...trying to avoid

I'm wondering if I can access an RMC-Scaler-C's RS 232 port from SSH or Telnet. I'm starting first with textconsole. I'm looking at the PASSTHRU and PASSTO commands, but having trouble with the syntax