开云体育

How about an analog inc for left/right that increments by 1 and analog inc for up/down that increments by 3. Run them into a sum. Add conditional logic for a wrap around effect. Obviously there would

i have DMPS100 & TPMC12v screen the screen disconnected i don't know the reason DMPS IP: 192.168.1.62. IP TABLE: 172.0.0.1 TP IP: 192.168.1.93. IP TABLE: 192.168.1.62 is this correct configuration?

I used batteryrefill.com for a TPMC10 and it didn't work from the moment I plugged the new battery in (constant reboot loop). Even if I take the battery out and run it only from mains, the same thing

Tried that also but the results were erratic - going from 1 to 3 with 'right' was fine, but then 'down' jumped to 4, whereas the desired result would be to go to 6.. Cheers

You could treat it like a 2D table. Use AINC symbols with min/max parameters set to the size of your item grid. One for Up/Down and one for Left/Right. Then use EQU symbols and ANDs to get digital FB

How about 2 ring counters to give you x, y coordinates and then an and statement for each button?

I particularly enjoy the Epson projectors we purchased that is Roomview compliant that does not work with....Roomview Enterprise. Throughly enjoyed that one. - Dan

Thanks for the reply. I tried that and could get the buttons from scroll through the icons in order, but they are displayed as follows: 1 2 3 4 5 6 7 8 9 ..and I'm unsure how to have the navigation

Off the top of my head you could use a ring counter to cycle through the icons and use the analog mode joins to show which icon is selected. The rest would be pretty easy logic wise. JRW

Energy Star compliance... -Neil Dorin [Non-text portions of this message have been removed]

Whyyyyyyyyyyyyyyyyyyyyyy why why why why would a manufacturer put Roomview stuff in their projectors and then turn off the web/roomview interface when you turn off the projector? Unless I'm being

Oops - finger slipped before finishing the Subject on that one (apologies)

I have a touchpanel menu with 9 icons - 3 rows of 3. I'd like to use the up/down/left/right buttons on the panel to scroll/navigate through the icons, with 'ok' selecting the desired item. Obviously I

Any luck getting direct service to Spotify later on? I dont own none of this media stremers, but did downloaded the Module and check a review and its quite promising not to be tied to Apple.

Thanks for the directions!!! -- *Jesus Tossas* * * *Technology Architect, Audio Engineer, Programmer* * * *787-460-1223* * * Contact Info <http://uqr.me/jesustossas>

I'm smack dab in the middle of a project with just shy of 70 of these combos. Each "station" has a local display that needed RS232 control, while the rest of the functionality goes over the network to

If you remember later ones installed get a review of the experience! -- *Jesus Tossas* * * *Technology Architect, Audio Engineer, Programmer* * * *787-460-1223* * * Contact Info

If it's like any of the other TVOne horribleness, pressing buttons on the unit itself should generate strings that appear coming in to your com port. Other dreck I've worked with from these folks

I have a tvone c26104 that I am using in a current system. After about 2 mins of looking at it not working over 232, I switched to IP. I don't know if the cable was pinned wrong or what, but I have

It works with both.