开云体育

We do as CK has listed, although usually we have been using 2.4 just for that extra bit of range- I wouldnt think the speed difference of 5ghz is necessary for these. Along with the newest firmware

Hi, I am curious does anyone have any experience using Extreme Networks WiFi access points.? ?I am looking to add a WiFi 7 offering and the Extreme Networks the AP5020 on paper looks better than

Boy, I feel your pain!!!? And I wish it was just the TSRs!....:( Hopefully Dave H will chime in tomorrow, but here's a couple ideas: - You do not need a separate SSID for each remote - The support

I would like to get to the bottom of this debacle once and for all!!!!!!! So, if someone from True Blue could chime in also, that would be fan-freakin'-tastic. One of my installation team just got

Does anyone know CEC commands for volume control on Samsung Frame TVs? Thanks in advance Avtar

I'd like to thank the 4-Series and Toolbox for provide the opportunity to wait more than work. For giving me ample time to brew and drink coffee in the morning and? to also pull out my hair when that

That is essentially how the TV Presets Channel Control v1.0 works but I know some Crestron modules can be polluted with over programming. I will try to use Simpl logic over the module to accomplish

Debugger shows correct data. Channel number and IR Pulses

Does it have an API/documentation? Michael

Thanks for the reply but they actually have and IP module and it works great. ?One of the best motorized mount I ever used. ?Sleek quiet with preset etc . ?only thing is o don’t think they sell

Are you sure its the presets module, or could it be your IR driver sending out the double pulses? Do the double pulses show up in debugger coming out of the presets module? We use them on every job

i tried this all methods and no hex code is given from blue star [email protected]> wrote:

Are you working in Simpl or CH? I work in Simpl and use a Serial to Analog 16bit, take that analog value and feed it into a keypad decoder 12 module. Some other small logic after that, but the keypad

Resolved - had an outdated .clz - Jeff at CC flagged it

Did you try calling their NJ distributor? * * Stirling Communications Supply Co. * 29 Poplar Drive * 07980 * Stirling, New Jersey * 908-604-9360 ( tel:908-604-9360 ) * www.stirlingcomm.com (

I am using TV Presets Profile Manager v2.0, TV Presets CRPC Interface v2.0 and TV Presets Channel Control v1.0 and when sending out channel numbers to IR Driver I am getting duplicate Numbers on

DM and we can check it out. Nicolasfreda at Hotmail NFH

I am looking for someone, that helps me (not for free) with converting my project. I don't have actual SIMPL and VTPro, but have converted VTPro project to Smart Graphics on my old VTPro, so now I

Does anyone have infrared ?codes for Vogel’s motorized tv mount. ?on site and don’t have a ir learner with me. ?Thanks for your help

Have you tried pulse IR? Is that IR command a multi-mode code? Do you have the source HEX code anywhere from Blue Star that you can try pasting in as opposed to learning it?