开云体育

Great article Jay! Thanks for all the work put into understanding the details and gotchas. I currently have a need to replicate Zigbee commands sent from a Connex heating controller to multiple

Hello everybody, Got a CP4 here on the latest firmware (2.8005.12) that for whatever reason won't take a program load. It takes ages for the "time remaining" to go away but after the fact it still

This is weird as I used to do all code in simpl and only used to open doors or gates in 2n using touchpanels in Rava sessions with DTMF tones firing off the 2n switches.. You could still do that if

YYZ... I knew someone would notice :-)

I posted a compiled.zip? that contains the Honeywell Vista 128bpt module set that contains a fix for a severe latency issue on zone status.? The modules affected all end in 1.2.1.? Please note that

The following items have been added to the Files area of the [email protected] group. * /pa-detton-honeywell-vista-128bpt_compiled.zip (

Side question dose anyone know if I can control the vista 21ip over eth or do I have to get the 232 module? [email protected]> wrote:

I would like a copy Sent: Thursday, February 20, 2025 7:46 PM To: [email protected] Subject: Re: [crestron] Honeywell Vista 128BPT disarming issues Hey Tony, I have a Vista 128bpt in my home. I

I am dealing with a similar 2n device for home use. Got the API working, can do some cool some stuff with automation etc. But I can't find any controls for volume adjustment (master level, call level

I'm not sure when it changed, but D3Pro now uses a newer scheduler module that generates two additional fields between the name and timebase. They're mentioned briefly in its Help text, but without a

Yes an Arduino can do this… the Wiegand signal is pretty simple and matches the 5 volts of the basic Arduinos that are most suited for this. What do you want to receive in Crestron, RS232 or

Anyone know of a good Wiegand interface that can sit between a Wiegand keypad and the crestron so codes can be changed on a touch panel instead?

Thanks Jay!

Just an FYI for anyone trying these out. I tested & successfully used the hex codes for off and the 4 HDMI inputs for a while. They have in recent weeks stopped working. I suspect TCL killed them in a

YYZ...nice! ;-)

Hi, I don't actively use the module myself anymore but I haven't heard of any reported problems with recent iOS updates.? That being said, I would highly recommend using the PushOver module instead

I have seen this issue in HR-150s. sometimes i have to spin the batteries until they work. I know its weird.

Just checking in on the health and status of this module - I have a client asking for it (I guess they found it themselves). Safe to deploy in 2025 with cuurent iOS ?

Ah, found it.? It was the HR-310 that had a firmware update to correct an issue with the battery being drained.? So probably not would take care of your problem.

I believe there was a firmware update to correct this issue.? Check the firmware version and upgrade if necessary.? However, I cannot remember if the update is needed for the gateway or the remote