开云体育

The idea for the MeatStick grilling thermometer was hatched when a group of friends became distracted at an afternoon barbecue and overcooked their steaks.? I've written several articles about the

I'm no expert, but my gut and my troubleshooting rules ask: what IS different? -CAT cables all good? -addreses/IP table(s) -controller model? -controller FW? -is it a managed switch? SOMETHING must be

I've seen it on a CH5 webpage where holding a button will give a momentary press. Rinse, repeat and it will then show my holding the button down [email protected]> wrote:

Just for big picture perspective, since Crestron fully supports talking TCP/UDP over the network, nothing stops anyone from leveraging that capability to just talk to Crestron by developing native iOS

What would explain why the same VTP project on two different TSW1060 panels of the same firmware ( 3.002.1061) works in one location and not the other? At both locations they pass TESTDNS

Regarding the play/pause FOR RESI...the older Crestron app for Android (not Go) supported notification widget buttons. It was so convinient there, I had play/pause, prev/next and volume contol, 6

Do you have the iPad set to go to sleep? Did you try turning off the sleep and leave the screen on and make the customer manually turn it off when done? Yea not great for battery life but the device

I notice this specifically with CH5 but I notice it more on the x60 series, especially the 1060.? My theory is that the same hardware drives a larger screen at higher resolution, but maybe it's my

We desperately need to have a fix for this connection times are getting slower and slower. many customers now increasingly frustrated with connection times by the time they wake the app up to pause

Thank you for all the suggestions, everyone. The two processors and touchpanel are all on DHCP, plugged into the same switch. Their gateway/subnet mask information are all received from the DHCP

Thanks John. I solved the problem this morning. I’ve been using the Alexa app on my iPad. This morning I had to recharge my iPad so I switched to my phone. Suddenly there was a message to relink my

Jay have you tried a processor reboot? Any site where Alexa stops working that I have seen a processor reboot fixes it. Seems to be necessary after a long period of time like a year or more.

The light bulb at the bottom to go-to the lights page. Then it just pops up at the top.

Hi Eric, Which light bulb in the Alexa app? When I look at my Crestron devices in the Alexa app they say "device is unresponsive".? If I try turning a light on/off it says "server is unresponsive".

When my system disconnects, if I launch the Alexa app and select the light bulb, if not immediately then after a few moments it will say "Crestron is unlinked, do you want to relink" at the top of

Thanks Gary.? That would be great! There are three key voice commands we're really missing.? I'm going to move those to the hubitat.? The rest can wait until Thursday. Thanks again Jay

I'll be at this project on Thursday, I'll document the process and get it to you.

Thanks.? The only option I'm seeing is to disable the skill and then re-enable it.? I know if I do that all my linked Crestron devices will go away and have to be rediscovered.? This will delete

I don't completely recall, I just dug around until I found a button that re-enabled it. I still don't know what causes it to disable itself, but it has happened several times since then, and the

Thanks Gary!? You are right.? I just played with the skill and now it is telling me that the Crestron Home Automation skill isn't enabled.? What process do you use to re-enable it.? I didn't see