开云体育

Did you update the firmware? Older ones had issue with NO TCN FLOOD commands not working properly. Although that will require a topology change, such one of the switches dropping and reconnecting.

Thanks Both! Appreciate the help! I will take alook at that video. Perhaps maybe I will test by moving the querier on to the access switch, where most of these encoders and decoders are and not the

So two things... L2 Multicast will always go to the querier, best practice in simple configurations IME is to have the querier on the switch hosting the majority of encoders and you may need to make

Sounds like something we were kinda running into on some Aruba switches too. I don't know what the Cisco equivalent is, but it could be related to this: https://www.youtube.com/watch?v=BqlGlY8GjNM

I have been running Crestron software on Mac computers since 1990 using a variety on means. I've been using Parallels since Intel Macs and am now running it on an M3 MacBook Pro. USB is problematic,

Oh, right on, great to know. I either missed that possibility completely, or gave up before that became an option. My long term favored solution has just been to dedicate a Windows machine for running

Mike, you can run the wifi in bridged mode. I did this for over 10 years on several MacBook's. The only system I ever had an issue with is Ruckus. By default they prevent this. A simple command on the

The problem you are having isn't normal. I ran a few different MacBook's until they went away from Intel, I never had the issue you are having. Try changing your network settings.

The operative issue here is how you connect to the network. Also, WiFi and Ethernet have two different stories and two different solutions. For the purposes of this message, caution for similar

Have been running Parallels on all machines running back to 2014 after I was tired of getting the blue screens of death on Dell computers. Haven’t had any issues other than on my 21 32GB M1 16”

I have not been using Parallels, but duel boot instead.? It can be a little pain to reboot if you need the MAC side, but I have not have any issues at all using the Macbook running windows with

Hi, I am working on a project to implement Creston NVXs, Q-Sys etc, I work on the network side so don't 100% understand all of it. We are having an issue where ports connected to NVX-D30 at random

Ok great, thank you for that info! I will definitely try VMWare Fusion Pro, because I am sick and tired of carrying 2 laptops with me everywhere I go. ?

Chris, I have been using Toolbox on my Macbook Pro via VMWare Fusion Player for about 2 years now.? It works great, as long as I don't try to connect via USB cable directly to the device.? VMWare

Has anyone been able to successfully run Toolbox on a Macbook Pro via Parallels? I know this question has been asked in a previous thread from a few years ago, but I was hoping there would be some new

Just use a contactor with the appropriate voltage on the coil. Then you can use any thermostat [email protected]> wrote:

Thank you for your feedback on our interface. To assist you further, we offer several resources: ? *Workshops* : We conduct regular workshops to help users master our platform. You can register for

Is it possible to update a .dll file to be compatible with the latest version of the NewtonSoft.json Compact software?

Thanks Brian. After my recent article on integrating home assistant (HA) with Crestron (https://restechtoday.com/my-experience-integrating-crestron-and-home-assistant/), you might check if there is an

I'm at the point where giving up is the only option as well. Regarding NuHeat, I went back and forth with them and Intersystem Controls for over a year to finally get it working. Finally, about 2