开云体育

This issue has been such a pain for such a long time I decided to create a macro on MobaXterm and assign a hot key to it. Before uploading to slot-1, for example, I trigger the following

Here is a solution. Crestron should have written Toolbox in C# not SIMPL+ :) Thanks

Here's what I've found by aggregating this thread and some others, and from my own testing. Feel free to copy this into a .txt if you want to hang on to it (Courier font will keep the alignment). And

Light Sensor - URC Automation (urc-automation.com) ( https://www.urc-automation.com/product/sen-lite/ ) I've used these for monitoring power LEDs on cable boxes, a little more finished look then those

FYI - I've purchased some of the recommended photo-resistor relay modules.? I plan on trying them out and writing an article about the whole topic if they work out. Thanks Jay

Can you solder wires to the led contacts on the board. It should be around 3.3 v dc and use a 3v relay for contact closure? [email protected]> wrote:

Glad it is working for you.? Your webhooks looked fine so I've been scratching my head as to what could be wrong. Thanks for letting me know Jay

All good now, silly mistake. Changed IP address of my controller and didn't reflect that in the Comm Manager. So H&T Gen 3 works!

http://10.0.2.24:9000/plus-ht/sensor/temperature/${ev.tF}/ http://10.0.2.24:9000/plus-ht/sensor/humidity/${ev.rh}/

Hi Jeffrey, Send me what you have set for the url actions.? That is the most likely issue. Thanks Jay

Does anyone know of or have a module for SIMPL for control of a Honeywell Resideo T6 Pro Smart thermostat? Cheers, Michael . . .

@jbasen, Just received a Shelly H&T Gen 3 and realizing it may be different from a Shelly Plus H&T. Cannot seem to get any reporting of temp/humidity. I did set the URL actions, but still no data

Personally, I would use a garage door magnetic contact for this. I've had great success with these Seco-Larm SM-226L-3Q Overhead Door Magnetic Contact, 2.75-inch Gap, Open/Closed Loop Circuits (3

That’s why I just delete the DLLs rather than the entire folder – it’s enough to stop the program from being able to restart itself but not quite thermonuclear. -- Lincoln King-Cliby Commercial

Thank you very much

YoLink is a smart home product line offered by YoSmart.? YoLink devices provide up to 1/4 mile of range because of their use of LoRa wireless communications technology.? My latest article looks at

I also notice on most of the 4 series processors when I connect to them in System Info. it takes a few minutes to populate all the info fields. It will populate up to Slot 1 and show progress batr to

Using the web interface and stopping the program is just as unreliable as using toolbox and text console. Its luck of the draw if it stops cleanly or not. I would rather not delete the program folder

I've been using the web interface to load programs on the 4 series processors. It works reliably most of the time.

I've experienced similiar issues myself.? Based on some other rumblings in this particular forum other have suggested that this maybe either a f/w level issue or a toolbox issue.? I've tried a