开云体育

My guess would be, Probably because the CP3R doesn't support OS3 or OS4

I'd be curious why you wouldn't just migrate the house from Pyng to Home on OS4 on the Cp3r and dump the pyng hub (at the only expense of a new gwexer maybe?) You'd have MUCH better UX and processing

Thanks for this, yes, I see the way the IR signals could be detected in real time and send via RS-232. The question is, as you say, can these commands be received and retransmittted at the other end

Testing an NT display with the module, I found that the feedback for power status wasn't what the display actually send. I modified the module with the actual observed feedback. Here's what I used:

I have used larger ones just fine. I don't know about 64 though. I think the largest I used was a 32

I have a little smart graphics fun project that I'm trying to load onto a Pro2.? Getting a insufficient memory message when I try to load.? According to what I read, the memory slot on the back can

NICE! That worked. I used a gesture canvas as a way to move around a parametric EQ. The Y axis controls gain and the X axis controls frequency. I made a S+ module that builds a string that looks

Hey Don, I'm afraid I cannot be of any help on this one since I also lack experience with Home. However, it is great to hear you are still out there delving in. Best of luck!! Dennis Sweet

Hi there’s no way to do it natively. but you could try to convert the CP3-R into a CP3 for Simp Windows and use de Pyng Modules that way you can send and get signals from Pyng / Crestron Home to

Disregard. Been awhile since using AVF. I needed to go to Manage Devices and actually add the driver for the projector. After that I was able to assign the HD-CTL-101 COM to it.

Hi all, Is can control crestron NVX system with kramer control system. Sent from Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Friday, June 7, 2024 2:15:45 AM To:

The Global Cache GC-IRE might work, connected to the NVX decoder's RS-232 port. I'm not sure if its serial output could then be routed directly to a Global Cache transmitter in the program, or if

All, I cannot get CEC to work with any of the samsung displays here on site. They are mix of Signage and OFE consumer units. None of them work, always get '@E' as reply no matter what I send or what

Yes, there is IR ports on the DM-NVX transmitter, but my problem is to grab the IR signals from the cable box remote at the NVX receiver and send them in real time to the NVX transmitter.

Can anyone tell me how (or even if) the power commands are managed to a display, when a HD-CTL-101 is added to the IP Table of a MPC3-102 in AVF? I have all the gear on my test bench except for the

Do you not have a processor or NVX transmitter at the remote end? You should have IR ports there.

Hi, Could you share the Reavon X100 driver also with me? Thanks in advance, Eduards

Hi, The analog outputs 1-2-3-4 will always correspond to zones 1-2-3-4 in any situation. There is no special programming needed. Though, if you want it to be a pure line-level output instead of

Hello all, Does anyone have use the 1-2 3-4 analog outputs on this amplifier? Is it works like the unbalanced output of the C2N-AMP 6x100? I don't see any instructions to activate them. Thanks. Angel

You totally could do it exactly as you propose for debug purposes, especially if it's just for inspecting variables in real time and you don't care about packet loss. For me, I'm actually driving