开云体育

Thanks for the link! However, as someone else mentioned, it's very sparse on details - and rife with spelling errors :-)

Well, woo hoo.. Finally, an app that works on 64bit Android phones. Downloaded, tested and confirmed from the client just now. It is about freaking time! Pat M From: "[email protected]"

Thanks guys for your recommendations. It came down to not having the \n inside, at the end of the message and also I had to split it up into two lines on the SIO.? But it works now.

I just went through this today and hadn't seen this topic. Would have saved me some troubleshooting time

Found it: https://www.crestron.com/Products/Control-Hardware-Software/Software/Apps/CRESTRON-GO-ANDROID

Where are the release notes? Checked Play store, communities.crestron.com...what am I missing?

Didn't make it all.? Next load they went fine.? Chalking it up as a fluke

The following files and folders have been uploaded to the Files area of the [email protected] group. * /Sony TV Example_compiled.zip (

You can use the certified driver as well.? You need to enable both the password and simple IP control.? I'll post an example that I was testing.

I just emailed you an old module for the MRC88, which I think uses the same protocol.

Such as?

Does anyone have a module for this? I know it's an oldie but the client has 3 of them and they still work fine. I have the protocol I could make one but didn't want to reinvent the wheel if

Since I'm rolling a MC3 in the shop, do I have to enable security to use this app?

Hi, you were completely right I totally forgot about the https, now i cn use debbugger and run my test softwares. Thank you :)

i agree with hunting for discrete commands; if you wanted to play around with some simpl+ (or c#..) see if this works for you? int presses = 0; int delta = currentInput - desiredInput; if (delta < 0)

Looks like this won't connect to my DIN-AP3 at home as min FW requirement is 1.8001. I'm running 1.6 at home due to various issues with DIN-AP3 running later FW.

Thanks for the help. Got it to work. Issue was the setup/init sequence. Once added, the cam control is good to default id of 81.

Will only be free for a short time

I like the idea that's free, that means I can use it on my deGoogled phone.

I know this isn't the answer you're after, but if you want to save yourself development time (which you may have already spent), we have a module for this: