开云体育

I put all shared signals SG or not through Xpoints for a given panel, they aren't any different from regular panel signals.

Yes as Steve said above use the WIFISETUP console command. But make sure you have all the information correct as if its wrong you'll lose access to the remote. Last time I tried this was maybe 6

I have a system that our sales team oversold to tun on a DIN-AP3. It runs at around 90-93% CPULOAD. Every 6 months or so it seems to climb up a few points and at that point it gets unstable. But ive

Sigh!! It SUX to get old but still be able to remember when psychic mind waves didn't affect Crestron products (or their design team)...

Yeah,? watch out for Remote Sensors. They will only work with twisted pair wire, with 2 conductor wire you have to use a third party sensor. They are scary to pry off the wall once installed, and I

You feel dumb? I've been programming Crestron for 23 years, and I've not even heard of it? Then again, its not the first time I've missed the boat these last few years... Studio, no Fission, wait

Hey Chris, I haven't had any issues with either band. I have had mixed luck with them in general. On one job, we just couldn't use it because there were crazy temperature swings being shown. We even

Per my notes, you can setup WiFi via the usb port using the following command: wifisetup MYSSID wpa2 aes password Don't know if that works via a TCP/IP console or if it can be used to after the remote

Hi Ken, These don't follow the 'Standard' LG codes. I have controlled these only via RS232 at this point because the screens can not be powered on via network. I have loaded the PDF that contains the

Hi All Is there a way to REMOTELY (VPN) change which SSID a TSR is connected to? I've looked in Console help, the ToolBox function list and the web page. Could it actually be that Crestron expects me

Hi All, We're (finally) doing our first HZ-THStats on a project. 1. Is there a recommended Wifi Band that others' have found to be most reliable?? 2.4g, 5g or it doesn't matter... 2. Any other best

Has anyone have tried controlling LG86tr3dk lg createboard via ip? Need help/guide on how. thanks

In the PRO2 days 80% was the rule of thumb... Today.... Is the system stable? I wouldn't be overtly worried about 82% as a hard number if it's pretty static... On the other hand if it's slowly

Sorry, I feel dumb. How do you actually use it :)

Though the 6x100 is pretty old in terms of Crestron tech and Authentication, I wonder if it has something to do with an AUTH mis-match? I started to see this issue with CEN-IO and GWEXERs where the

Probably the IP address issue.

There's a how-to on the GitHub page, on which point are you stuck? Can also recommend XCA for creating certificates https://hohnstaedt.de/xca/index.php/download

We replaced a customers MC3 with MC4 and everything was working afterwards.? We did some upgrades to add another room and now the amp has stopped communicating.? Today we swapped the amp with a new

an RMC3 loaded with my code uses 82% of memory is this something i should be worried about? mark

My old programming template, that is located on my GitHub (https://github.com/jbasen/Crestron-Template), is all based on crosspoints.? The hardware drivers for touch panels and sources is all out of