开云体育

Thanks a lot, problem disappeared once done the account setup in both devices :)

Crosspoint is a best practice. Its better to pass all the signals from the Crosspoint in order to avoid any confusion. And if you don't use Crosspoint then you just need to change the logic of the

Hey Everyone, I am programming a project with multiple touchpanels and a lot of sources so I decided to try my hand at Crosspoints. I pretty much get the jist of how it all works but I'm curious if

Hey Joe, were you able to control the ILC lighting interface? Im stuck with the same issue you had

hey caleb, were you ever able to square this away? Im working with the same device and cant figure it out

I just found that article on Crestron website that looks to explain exactly what you are talking about right ? Will try tomorrow as now I'm no more on site and report result ;) Vincèn

Authentication where ? in processor or the device CEN ? or both ? you speak about the new security settings where you define login/pass with rights ? do I have to use same at both ends ? Thanks

I could be wrong but I believe you have to set authentication on for the gateway to work.

Yeah, I'm still running this dinosaur of a security panel because it otherwise works so well, and isn't worth trying to replace :) The way I see it, there's room to pass way more than 8 notifications

Hi It has been a while I have not played much with Crestron stuffs and so a little rusted so I guess my problem is probably missing a stupid little detail :-D I encounter a very strange and ennoying

I'm pretty sure Autonomic is compatible with Crestron Home, although I've only used it with Simpl.

A blast from the past… Hi Mike, Around 2008 I wrote my own module that could run in transition mode. I saw the specific case you mention during Disarm On Entry where the Disarm command took a while

The above suggestions are good, but not compatible with Crestron Home, as far as I know.? The only non-Crestron matrix that I have found to work with CH is AV pro edge.? They have a 12x12

My favorite non-Crestron multi-zone amp is the Autonomic M801e. It integrates very well with Crestron, is reasonably-priced, and sources connected to one amp can be streamed over the network to other

It depends on their work load. I did mine early this summer and it came back really quickly. Just a few weeks. On the previous exam it took them 60 days. I think you have no choice but to be patient

Solved. was using ssharpappdebug on instead of SSDEBUGENABLE ON

I had it too. I used my iphone when i’ve noticed that issue. I will try later with my pc NFH

Shameless self-serving plug here, but you should check out C5 Debugger ( https://jaylia.net/wp/product/c5-simpl-debugger-free-trial )

yeah, same issue.? ?Today was especially bad as I was working with a PRO4.? I have the same issue with MC4 in my office.

I submitted mine in early October, got told 60-90 days, and have not heard back yet. A guy I know on the inside told me he'd be surprised if they got back to me before the end of the year, right now.