开云体育

You can go to Amazon, get a nice MeanWell 240w 24VDC DIN power supply and power the unit via the Crestnet port. ?If the card cage is empty it will tuck right inside that space. ?If you want to get

Something I’ve been doing for years with AppleTV is to just use a generic Sony BluRay for my IR codes then going into the AppleTV settings, remotes and devices then learn remote. ?You than then

I already found this Crestron module on Upwork and it is working great.

the pro3 power supply is an off the shelf part MINT1180A2475K01.? You can buy online: https://us.rs-online.com/product/sl-power-ault-condor-/mint1180a2475k01/70151979/ Pro2 if needed:?Astec

You can power it off of the Cresnet port. Be aware that the processor with cards can require more than 75w.

Interesting, I had a project recently that used an 8x8 that we updated to the latest FW. We had an LG TV. I started out using the LX series driver from the CresDB, which I've used a number of times

FYI, I believe that you can power the P2+3 by feeding power into the Cresnet connector...I'm going off very old memory...

Well, I didn't have THAT issue... However, Earlier this week we added a new ATV to an older DM32x32 system. When sending IR out of the Endpoint, it was sending commands for about 2 sec. I really

I just noticed this the other day. I am going to try the one I have at home

Inside, no. The Pro2 has a 65w power supply that Crestron runs as a 75w. The Pro3 has a 180w power supply in it.

Will a Pro2 power supply work in a Pro3???

Tried these command sand they didn’t work. Very unusual. Only the \x01 starting commands work. Must be different commands in this camera. thank your for your help and response though

Sorry this will work

in visca serial entry in the SRGX module you need to send: Preset1: \x8x\01\04\3F\02\00\FF Preset2: \x8x\01\04\3F\02\01\FF Preset3: \x8x\01\04\3F\02\02\FF

I’ve tried the \x8x commands and none work. the commands from the module started with \x01

Yes SGRX you can send direct command in the visca input, work great !

Did you use a module from the application market? there’s a dip switch with http or rtsp but no udp dip switch

I do and SRG-A last week and there is a switch on the camera for UDP control

Hi Jeremy, Did anyone ever get back to you?? I'm using Visca over IP commands but can't get the Crestron VC4-PC3 to connect on UDP Port 52381. -- Doug G

Hi Ben, what do you mean by the jumper? I have a cable in the Lan and PTZ controls are working g but presets aren’t.