开云体育

Sometimes when a program is recompiled the IP table entries are in a different order. This will cause the warning. I have discussed this with TB but only in passing. I first noticed it with an NVX

I can answer general questions but I can't send code samples because the protocol is released to my company under NDA. That said, the coding was not difficult at all once the hardware is setup

I'm looking at some drawings for a system that uses this Evertz product and I need to price out time for it. Does anyone have some code examples that they are willing to share? I'm currently trying to

i found; " Hold SETUP button for 5 seconds to enable/disable" but... anyone know the textconsole command?

I think that there might be an issue with ProG deprecation and newer iOS software...I can't remember the details but others probably will weigh in...

Hi, I need to disable the physical buttons on the din-8sw8 module. Does anyone know how I can do that?

For some reason on one of my ipads I cannot bring up a full setup menu using this app. It only shows connect option and not the edit system option. I need to change the ip address in the setup due to

Job done 8 years ago, replace an IR driver, dumped then the warning shows up (IP table on this program is different than the one in the device).. WTF?, i had this error showed up multiples times on

I agree with Tony. I always have a separate IP-ID for each program that is communicating with the GW. Thus I would do this, whether in the same of different processors: CEN-GWEXER: I P-ID 03 -> CP3 IP

The "correct" method is for each program, whether on the same processor or not, to have a unique IP ID. losing

Thank you, TB was adamant that it had to be the other way, thought I was losing my mind. Sent: Wednesday, August 9, 2023 8:22 AM To: [email protected] Subject: Re: [crestron] Shared GWEXER You could

Can anyone confirm proper procedure for shared gateways, i have a CP4 running an AV program in slot 1, D3 program in slot 2, i have the ipid set to 3 and 4 in both programs. Just got off the phone

Thanks for the update!! Always appreciate a heads-up on these things!!

Just wanted to give this one a quick bump as we had to deal with these this week.? We ran into a bug during install on the module v1.1 which displayed this error sporadically when changing setpoints:

You can say that again!...

Thirded.? They have provided great support for all their modules.? There is a little front end work you need to do to get this particular module working tip top, but the back end of the module works

Not sure why they don't work simultaneously but I'm suspecting it has to do with the C1M1 occupying the serial port. We were even on the phone with Elk tech support and it was never mentioned as

That's a rhetorical question, right?...:)

That got me too as we are new to Elk and evaluating the product. How could they not make them both work at the same time...

I'll give them a plug also. Great guys who provide good support for their modules...