开云体育

*..if they are wrong in the first try.” NFH

With p301 you have just a second chance to send corrections if they are on the first try. If that second try is not good, you need to wait 3 months to retake it. Not sure if its the same with 201, but

I believe you get 2 tries to take it. Then you have to contact them to take it again. At least that's the way it was years ago when I took it.

Hi there, this is my first post here.? I took CTI-P101 almost a year ago but only in the last couple of months or so have I had extended periods of time to look at and modify programs, and I think

Found it at Answer ID: 1001577, in case anyone is curious. Thanks.

Has it decreased to 10 resets? I thought it was 11. Unfortunately this is the only way. Good luck - I've had panels that still refused to factory reset this way.

Does anyone know the manual method for defaulting these panels? Touchpanel no longer accepting credentials even though I am certain they are correct. Now I need to factory default it manually but not

Maybe. If the programs are for 3 (and maybe 4, never looked) series you can recover the .lpz program from the processor. Then, if you're really lucky, when you compiled it you had simpl set to add the

Not unless it’s stored on the processor if it’s only the compiled files then your out of luck. Check the files using the file viewer in Toolbox.

If you have "Create archive and embed into compiled program" set in SIMPL, then you can for 3 and 4 series. It will be on the processor in the App** dir as a zip file. If that's not set, there's now

Only if you were putting the archive on the processor. It's a setting in Simpl that needs to be enabled to auto archive the program to the processor when you load a program. Sorry for your loss!

Hello all, I had an accident with one of my backups, and I lost a lot of programs in those disk. Is there any chance I can get them directly from the processor actually those programs are running? Any

I got this resolved, but I also noticed that the web interface parity setting for the iTach does not match the telnet interface setting. [email protected]> wrote:

Has anybody used Poly Eagle Eye IV cameras with Global Cache iTach serial ports?? I have two EE4 cameras here that let me power them on and off from my VC-4 instance, but will not P, T, or Z.? They

No problem. NVX can even run on Cat5e so you have more than enough... I had a grounding issue with using unshielded Cat6 and a POE switch (Injector/power supply) early on. Had to ground the remote

My current DM system is now starting to show it's age. My house is currently wired with CAT6 & DM-8G cable. I'm planning on using the 8G infra-structure for NVX as re-wiring is simply not an option in

Ask it from Crestron. It’s not very difficult.

Thanks for the heads up, will give a try. Second thought, i think i saw this setting and already change to Always ON.....

EPson has a new setting in their projectors. Go under “AV Settings” under the menu, and turn to ALWAYS ON. By default it is set to only while on. I had to do this to a batch of L510U and L530U

I have 3 Epson projectors works fine on Roomview command via HDBT. The issue i have is one projector will lose Lan connection once it is power off. I can see at Crestron DMxMD, that DM port RJ45 Green