开云体育

Just a pin mapper right, not a certification?? I think a lot of installs get down without certification, pins out right but still isn't 'right'.

Has anyone had any luck using a different wifi adapter to enable Miracast functionality on an AM-200?

Does anyone know if there's a SIMPL# event I can use when a program receives an update request from a UI, in my case an XPanel?? I've been using an OnlineStatusChange event to "refresh" my UI on

This must work out of the box, there is no driver needed. If the Mercury does not show up as speakerphone on the PC when you connect it on the micro USB B port then either the cable or the port is

I believe that with the GWEXER, there is some sort of config file that theoretically allows for transfer devices from one GWEXER to another. BUT, I'm quite sure that you will not be able to move the

PJ failed already asked client to move POE for PJ to another port...

NFH, You are correct, it is a USB micro connection in the USB B jack, and it is connected with the correct USB-A to USB-Micro cable (came with the Mercury). Any ideas why the Zoom Rooms PC isn't

Similar Isuue with the connectors. My LAN Cable test (tried 2 different testers) Said cables checked out good. Then just replaced both connectors and it all worked.

Hi All, In a week I will be upgrading 2x CEN-RFGW-EX with 2x?CEN-GWEXER. The current gateways have around 100 devices already acquired, is there a way to "transfer" those devices to the new gateways

I just wanted to say thank you for your followup post on the fix. I had been beating my head against a wall for 2 hours on this.

Call AVLinkPro . . .Sent from my Verizon, Samsung Galaxy smartphone

Those are the work of the devil (IMO). There is no reason for them to exist. The connectors I referenced were good old standard (though not sure “better quality” would apply to theses … can’t

fixed the DM issues now client wants to remove local PC and replace with BYOD solution PC has audio from Clearone (USB) & video from Vaddio camera (USB) i can see getting a USB->analog audio and plug

i did wiggle them, and they were unplugged/replugged many times, never worked until they did i'm wondering if there was something wrong with the Crestron POE switch supplying power? moving the POE

Had many problems with Easycrimp RJ45 connectors. ?DM on DMPS’s seems to not like open ended RJ45s. ?Any slightly movement and they work then stop then work. ?All cut off and old fashioned better

Hello. I inadvertently enabled authentication on a TSW-760 with firmware 1.000.0059. (command "auth ON") Now I'm unable to access it as my credentials are not recognized. I did the same procedure on

Hi All, I know historically that Napco has been pretty much a non-starter as pertaining to *good* integration, but I haven't looked into it for years now... Has anything changed? Or is it cheaper to

DoorBird works well with Crestron directly, and shouldn't require the AVLinkPro. What specific functionality is the latter adding? I've used ControlWorks' DoorBird Simpl module in several systems

I have seen some cables/connectors where the contact surface is not quite up to spec and a slight wiggle will make/break the connection enough to make DM unhappy (remember DM is more sensitive than

I don’t know the real answer but… If you have a system dumping stuff to the log with enough verbosity that the flush interval is 30+ minutes… take the half hour to go get yourself a stiff drink