开云体育

First off I’m not a programmer, I’m an IT tech overseeing a jog done by Crestron programmers. We current can’t get out of the HBO max app on Apple TV with the Crestron remote. The programmers

I need to set the version identifier for an httpsclient.? I can do the following HttpsClient client = new HttpsClient(); client.Version = ??????; Version takes a string but I can't find any

Hello, Has anyone had any issues with an HP Spectre running Windows 11 not being able to see USB Devices (specifically a CP4) in Toolbox Device Discovery? Ethernet works fine. I have an older Spectre

@Andy, I know the password for the device. That's not the issue. The issue is the password is preventing the VC-4 from communicating with the DMP (At least that's my theory). I'm fairly new to the

You can also change the timeout to a very long time on the Extron device.

Password needs to be set on all extron devices now, it is the serial number of the unit

In the Crestron CTI website there is a dashboard at the bottom right that will show you any exams you have available.

Yup, What Dave said about SETCSAUTH... Lost a half a day and 2 calls to tech support to find this out last year...Stupid, crap Auth...:( (and Crestron not updating info on this things for far too

Agreed! Also, one place to make changes and updates!!? Think if you wanted to hide or show an element and you had to update and load 10 projects... (Frankly, anything to limit how much I need to

You need to send something regularly to stop the connection dropping out but from vague memory I had issues from overusing sending verbose3 so I just send that after connection. There's a general

Try clearing the password. So there’s no password to log onto it. Then unplug the power and plug back in. That usually works for me

I was to reply the same, happened to me the other day with DTools. But i see the OP deleted his message, thou the answers are still here. Cheers

A thing to be aware why things like this can happen is when you have page flips assigned to buttons, which runs inside the interface only, and subpages driven from the processor, which needs proper

23. And I've followed instructions posted in previous discussions. I've got an oscillator pulsing verbose 3 every 30 seconds. I don't know if that's necessary. The posts were from 2018, so could be

Hi Scott, are you using port 22023? Or port 23?

The WHO command on the processor should confirm which IP Address is currently connected at that IP ID (so you can confirm it matches the CEN-IO-COM-102 in question). The CEN-IO-COM-102 likely has

Use Alt+ Tab to determibe if its actually open but iff screen. crestronpro@...> wrote: Lee Baker Crestron CSP 615-306-4133

I'm implementing the DMP 128 plus module for the 1st time and I'm not connecting to the device.? IP table shows device as online. ? Debugger shows a reply from the DMP that says "password:" I'm sure

Have CP4r connect to two DIN-CEN-2POE (amongst other things). Whenever power goes out to them, none of the attached devices work when power comes back. The rest of the system works fine. They seem to

The processor's IP table shows the cen is connected. The cen's IP table shows the processor is disconnected.? Any advice?