开云体育

We have a takeover job where we just started to get the system ready for new programming, and it has a CP3 and a PRO3 running 1.501 fw. So I was curious to see if I would run into the same issues when

Good morning guys, I'm upgrading an old AV2 install to a CP4, and the client wants to keep the old TPS-4Ls in place until the house is decorated in the next year. I can see the TPS-4Ls drop into the

I don't know if it's already been mentioned, but couldn't you add an old PRO2 or AV2 for only the Mobile Pro symbols, then EISC them over to the 3-series program?

It is a CP3N and as luck would have it I have that exact memory card on the way from Mouser. ?I unfortunately don’t have any other CP3N processors to get the image from. ?Mouser apparently has

The higher ed market is a pretty sizable chunk of AVIXA's membership. There are a bunch of us at universities that wear the programmer hat pretty regularly. It'd probably take a pretty sizeable

So just to follow up… After repeated attempts with tech support to ‘roll back’ the FW on this unit it finally threw its hands up in the air and gave up. Crestron issued an RMA and we sent it

Are you sure 4K is required for the planned application? Going below 4K could drive cost significantly down. Cheers, Thorsten Von: [email protected] <[email protected]> Im Auftrag von ckangis

Chris, I've used DPI projectors in several commercial projects over the years, and they've been extremely reliable. I don't even know what reasonably priced means anymore. DPI E-Vision 11000 4K-UHD is

Hi All, We're working on a church project and need a couple *reasonably priced* 4K projectors that have 8-10,000 lumens. Any suggestions? TIA!!

Hi, I'm looking for the way to control PTZ Hikvision cameras. Could you share the code which uses SimplSharpOnvifInterface.dll? Many thanks.

1. What is the reason that you're looking to use a Control subnet? 2. you can use a reasonably inexpensive router to set up the same configuration via VLans, one for the processor and one for the

Is there some particular reason you have to have the control subnet?

Hello, this is my first time setting this up, and it works great except the Lights page, for some reason it will not populate, the module is straight forward and i dont see any troubbleshooting that i

Hey everyone, My company is in the middle of a project in NYC and need a programmer who is experienced with C#.? Can anyone point me in the right direction?? This project is very time-sensitive.?

Yes you are right. The more I read about the AP4, the more I have no solution to this control subnet port mapping. Now I'm lost with what to do next, sigh.

You’re going to find this tough as the DIN-AP4 processor doesn’t have a Control Subnet physical interface or internal router. I’m guessing the AP4 is a substitute for a CP4N? I think a design

G'day all, Has anyone successfully added or modified a program file on a VC4 using curl and the REST API from a command line? I've tried but have been unable to make it work. I can query the existing

I'm using an AP4 processor and a program needs to configure the processer with a control subnet. The port map on the control subnet requires 2 ports: External 3072 to internal 3072 and the control

Wondering if anyone has an IR file for one of these units?

Yes, Lincoln is correct.? You want to use the? "uprogcmd" symbol.? Not the "console" symbol as I incorrectly stated.? That's what I get by doing thing from memory rather than looking at what I