开云体育

I'm using an AP4 processor and a program needs to configure the processer with a control subnet. The port map on the control subnet requires 2 ports: External 3072 to internal 3072 and the control

Wondering if anyone has an IR file for one of these units?

Yes, Lincoln is correct.? You want to use the? "uprogcmd" symbol.? Not the "console" symbol as I incorrectly stated.? That's what I get by doing thing from memory rather than looking at what I

You could route the output of the UCMD symbol to a SIO – you could then match something like “PROJON” (without the quotes) in the SIO and the corresponding digital would go high when you sent

Tim's code from Masters 2022 MSS-431 has a VirtualConsole class suited to this purpose. You can telnet in and even have it re-print the previous debug messages. You can find it linked from his

You most certainly can use the USRPROGCMD command to send serial data out of the RMC comport with a little bit of SIMPL and/or SIMPL+.? I use USERPROGCMD all the time to check the status of of

Thanks for answering, I was pretty sure by now that it wasn't possible. I have a few goals. One, was a simple curiosity what/how much can be accomplished from my VPN, without having my Windows VM

AFAIK, there isn’t a way to access a serial port on an endpoint in that way – passto /passthru have been historically used to access the console of devices (and in a very modal method – e.g.

Get a Niles APC-2 from eBay, plug the projector into the "Current Sensing" outlet, and use the 12v output or relay output to drive the projector lift.

Thanks John. At this point, no Crestron control, just manual. AV Receiver trigger controls lift (old Panasonic projector melted from being sent up too early from AV Receiver trigger...trying to avoid

I'm wondering if I can access an RMC-Scaler-C's RS 232 port from SSH or Telnet. I'm starting first with textconsole. I'm looking at the PASSTHRU and PASSTO commands, but having trouble with the syntax

Does anyone have information on the Colorlight X8 video wall processor? I've controlled the Z6 before, but I have no idea whether the X8 utilizes the same protocol, and the manufacturer is... hard to

Hi! I would like you to help me with creating an IR driver for a Matrix HDMI in Crestron Home, the procedure for creating it in ToolBox I can do, my question is which type of device is most suitable

Hi! I would like you to help me with creating an IR driver for a Matrix HDMI in Crestron Home, the procedure for creating it in ToolBox I can do, my question is which type of device is most suitable

https://www.crestron.com/Products/Control-Surfaces/Room-Availability-Signs-Accessories/Room-Availability-Signs/SSC-100-EL

Yes sorry... Program Instance. In our case we use a spare room license for debugging, and stop that program when we are done. You could actually do something similar by creating a program/cron that

How is it controlled? do you have a link to where I can look at them

That's what we used in our studio at the office.? it works very well. https://photos.app.goo.gl/ATSTyzzPMkgrVsEd7 https://photos.app.goo.gl/xXmRj1iGDonqgZnU7

When we use Epson some of the modules hafe a Cooling_Down_fb that we use to put up a message on panels. You should be able to us this when it goes low to raise your lift.

How about one of those Room Availability Signs https://www.crestron.com/Products/Control-Surfaces/Room-Availability-Signs-Accessories/Room-Availability-Signs/SSC-100-EL Yea you would need cresnet or a