开云体育

here are some new modules for Yamaha Mixers: *Rivage PM V.2.0 (for Crestron 4-series only!)*

Thanks Jeff!

The SecureTcpClient is a raw SSL stream connection, sister to the standard TcpClient. The https does use SSL but, I don’t believe uses this connection class internally. We have not seen this issue

Tray, You have to send the MAC addresses both directions not just from the Remote to the Local. So Take the Device ID from the Remote unit and feed it into the input of the Local Unit Then also take

Jeff I'm not familiar with SecureTcpClient.? Are you saying that any module that uses an https client connection to a device is affected? Thanks Jay

If XiO Cloud isn't being utilized, You can disabled in Toolbox from the " Functions > Device Info > Cloud Services ( https://help.crestron.com/toolbox/#System_Info/Functions/Device_Information.htm ) "

Yes, the SecureTcpClient that is used by the Lutron Leap Modules (QSX…} is malfunctioning with the latest DB updates. You do not have to role back all the software however. The include4 is the

Bambam_101 if you are on the Crestron Home facebook group, you could unload those CP4-R’s pretty quick. There are a lot of integrators looking for some. Pat M From: "[email protected]"

Firstly, RS485 is wired differently to RS232, worth confirming you are wired as per the following: https://support.crestron.com/app/answers/detail/a_id/1634/~/crestron-com-ports---pinout-information

What about CP4 to became CP4-R ? is that possible too ? this will save a lot for the actual situation of all integrators

The TCP port for the connection to the Skaarhoj ("scar-hoy") device is 8899 I used a Serial IO with the following commands in ascii and used \x0A (Linefeed)? as the only delimiter but see what

Thanks, Yes, that part of the cabling is good. Although the NVX port labeling isn't real clear. I should have been more specific in my request. Am seeking advice on the programming. Thought it was as

At the PC end, you have to use the UCB-C port out of the 360s. Check that since it is a common misstake.

Hopefully I can save someone else a bit of time and headache with this info.? I found out today that the latest SIMPL 4.20 and latest databases causes Lutron leap integration to stop working.? I

Am looking for guidance regarding how to make USB routing work for NVX. These are 360/360c units, not using a Director. I can get FB from the control point (where the KB/Mouse live) and send that to

I am trying to write a program to control some motorized shades in an apartment complex our company has designed and installed. We have 7 motorized shades and the only functions I need them to perform

I share your pain.

Modules not compiled for 4 series processor. Open program then open modules affected (simpl+), recompile for 4 series and try again. Had same issue a while back. Tim

I'm quite sure that the FW the Answer ID references will only work with 3-series (CP3 specifically it seems). I'm sure that it's possible, but will Crestron provide this?... Re: TSWs - the fact that

Wonder if this would work for cp4r? Have a bunch here that were incorrectly ordered but never returned.