开云体育

Check for any ECCONNECT symbols that have a rogue DISCONNECT_ALL or Disconnect from E/C defined… I’ve never had crosspoints organically decay but I have inherited some abysmal programs with

I am using a For loop in simpl+? to increase and decrease and analog value and its working, But i also need to slow down the rate at which it steps through. does anyone know a way to make that step

Hi Group, Having some fun with Q-SYS modules version 5.0 and 5.1 that seems to be impossible to have them in the same database. After importing the 5.1 module, I was working on a system with CP4 and

Thanks Joe

Has anyone experienced cross points disconnecting over time? I’m on a takeover project where it seems like the crisspoints are disconnecting over time, and the only time the crosspoin connects is

I'm sure the Cool Automation is the easier path, but about six months ago I created C# JSON I/F module for 4x Daiken Emura system using their latest APIs and WiFi modules.? I made the module look

Worked for me too. https://www.crestron.com/Software-Firmware/Software/VisionTools-153;-Pro-e/Crestron-Smart-Graphics-trade;-Controls/2-17-01-01 in case anyone else runs into this.? Just download and

Thanks Guys!

Hi, Has anyone ever used a Crestron MTR Flex System with a third party Processor (i.e Extron, Kramer etc)?

Hard to say as it, again, functions properly about 1/2 the time.? Late yesterday I replaced the Sat Driver with the one specifically listed for Genie 4K models and it made no difference. There is a

We've had a fair share of Apple TV audio issues over the years as well and troubleshot in similar ways. If someone has the special sauce to get the most out of everything, I'd also love to know.

Yea we ended up going from a #if_Series3 to doing #if_Series2 / #else and that stopped the errors on the S+ compile. My gripe was that if you never opened up S+ and just compiled in Simpl for a 4

Yup, I understand, that how I ended up writing my own years back. I did learn a lot about the protocol in the process, so I’m happy to help if I can. Dave Sent: Tuesday, September 6, 2022 6:39 PM

Thanks Dave! Yeah, I'm bound and determined to figure this out, even if I have to write/re-write things myself...:) What's weird is that the MV commands that we send are just two digit (we don't care

Hi Chris, I believe that your assumption is correct. MVMAX should be the value of Volume Limit as set in the AVR and it should not change until the setting in the AVR is changed, This is how is worked

Hi Dave, If my assumption is correct that MVMAX is supposed to be the max volume allowed, there there's definitely something wrong with the feedback as the AVR 'Limit' is set to OFF and thus should

Is it that the TV/AVR Power On/Switching is not functioning properly or could it be that the DTV client is either Asleep or not syncing properly? I have not dealt with the new DTV clients, but I think

Has anyone had to control this lighting module?? Client wants variable (dimming) capabilities, but another contractor is providing the hardware.? I've only ever done Crestron lighting control, and

Bump...

Kiddies, Initial Turn On sequence with DTV 4K Client as the selected "Source" is rather flakey.? LG 55 OLEDB7P is being controlled via IP as is the Denon AVR.? Works correctly about 1/2 the time and