开云体育

Hi Tony, I think tying the operation of the bathroom fan to lights is going to work well in some bathrooms but not in others.? For example, if a bathroom has a small, separate room for the toilet,

If you SHow INTerface STATUS on the 9300 what is the interface status for the port the CS is connected to? Which processor? How many VLANs are in place and are you sure the CS is on the right VLAN? If

I might be over-simplifying it, but I typically control the bathroom fan based on the lights. If the lights remain on for more than X minutes, the fan is turned on. When the lights are turned off, the

Thanks Jason. Looks like I could easily integrate an IR proximity sensor with an arduino board that included WiFi. I could also tie in a humidity sensor for an all in one solution. Just not sure how

Hi Oliver, thanks for chiming in. Sure i know i can contact you directly, but i wanted to collect some experience from the crowd as well. ? I don?t have the NVR yet, currently looking at the

This is good news!!

I use an infrared proximity sensor in a wall box next to my toilet for this purpose. It's worked really well for years.

Thanks Thyce.? The two full bathrooms in my home each have a small, separate room that houses just the toilet and tub or shower.? So, there isn't a convenient place to hide a motion sensor.? Also,

I have this same thing in my bathroom. There's a motion sensor hidden under a pedestal sink that's aimed at the toilet. Works flawlessly. Although our new TOTO bidet seat makes the ceiling fan

Thanks everyone for your suggestions.? I was going to save this for an article but I'll share some more details.? My idea is to use this sensor for automation in a bathroom.? The sensor would

Has anyone used/setup a Cisco 9300 switch? I have used the SG350 and a few other brands of switches in the past with zero issue.? Out of the box, they work fine, or I have followed the NVX setup

Just wondering if anyone has had good success with sending file attachments from the SendmailSharp_r1 module. I'm testing with an RMC4 and emails are received fine but never the attachment. In my

did an 'initialize' and now it recovers from a power failure... no, not really, did once tried initialize/restore on 2nd mc3 - still won't start after power cycle can't find serial # in image to edit

Hi Thorsten, The model you have is an I-Series - it's the "-I2" bit at the end that signifies that.? Hikvision's models/series are a nightmare though... so I feel your pain. The true test as to

I have used these: GLS-OIRLCL-C-CN with some success.? It is possible to ceiling mount it and cover part of the sensor window with tape to adjust the sensing area.? ?It also has some sensitivity

Jay, I was thinking about using a camera with analytics as well. Many have people counting, trip lines, and even boxes that can be drawn around areas. The other option for a completely battery powered

You can just use the prox detector on the tsw-1070 as it is approximately worthless . . . From: <[email protected]> on behalf of jbasen <jay.m.basen@...> Reply-To: <[email protected]> Date:

How about a pressure pad on the floor? Something along the lines of this might work with a bit of hacking on the receiver.

Unfortunately, Crestron's online resources didn't help me much in starting off in Simpl Sharp. What I did find very useful was Patrick Murry's online courses at learnavprogramming.com. There are some

NVX does not deinterlace prior to encoding. Since the NVX-363 includes a scaler, it will always deinterlace first, so no interlace output is possible. NVX D20 and D30 do not include a scaler, so if