开云体育

There's a potential issue if the power supplies are slightly different. If you have two power supplies, one at 23.5v and one at 24.5v, the higher could backfeed into the lower and damage it if it's

Is the room you put the camera in hidden under advanced settings? This also hides cameras.

I am having difficulty understanding datatype conversion from SIMPL# to SIMPL+. Currently, I am trying to parse return data from SIMPL+ using my SIMPL# library. The return data comes into SIMPL# as a

Perhaps someone here smarter then me can explain why Crestron insists that a cresnet device can only be powered by a single power supply?? 2-24 vdc power supplies in parallel is still 24 vdc.? There

For anyone else not sure about the jumper, it's not something you unplug.? It's a wire that needs to be snipped or un-soldered.? I always knew of it's existence but never needed to deal with it

I must apologize in advance is someone has already answered this question.? I am trying to set up my first crestron home and I want to add in my Unifi Cameras.? I have added a manual camera but when

I loaded with toolbox and didn't notice the radio button about it being mobile vs xpanel.? Changed it to xpanel and now the url to the processor works:?https://172.16.64.21/ch5-test/index.html

you need to load it from the processor, push the ch5z file to the processor and use that link to open the web xpanel

After the first load it starts a 60 day count down timer for a free trail.? It is automatic and my timer started today.? From what I read it sounds like you can restore your processor and reset the

Does it still require a license on the processor?

I have downloaded the demo code and everything looks fairly straight forward.? I have loaded the program to the processor and can verify that port 49200 is open.? I set my processors IP in the

Correct.

Hi? i am having an issue with the dali driver of led strip, It shows failure when addressed on the dali commissioning tool but i can control the intensity of the light . But when i add it to a group

Completely "normal", how should the panel know if you want to use the slider or if you want to swipe between subpages?

So it's a vertical gauge on a vertical subpage ref list. If i put the same referenced subpage on a horizontal subpage ref list, it shows up fine...

I put a gauge on a subpage ref. The subpage ref list, says 'unable to show this control' or something similar. Anyone got ideas to fix?

A router can have only one input selected per output so you don’t have to worry about ‘cleaning up’ active if you’re using a router; a mixer can have multiple inputs so depending on the size

While the Tesira modules are rock-solid, the Nexia ones are pretty awful. I wound up just using the Audia/Nexia command string calculator (

I think you can use the "Biamp AudiaFlex+Nexia On-Off Control" module and select the 'Mute device type' as 'Router Crosspoint Mute'.? This would allow you to control the on/off state of each

I would also like to be added to the list.?I've been looking for this for a while now, I'm glad you picked this up.