开云体育

Oh, one more thing. Use the ZV server web page to confirm the Crestron route commands. There is a graphic for each TX and RX in the system and if you mouse over a RX, you will see what is routed to

The API for this is rather easy. I just did a project with server and about 35 endpoints. User manual is here if you do not have it already:

How far is the CP4 from the Marantz and APpro?? If they are on a different electrical subpanel you can get surges even though the ground too.? My policy is if an RS232 device is on a different

Are you getting a busy signal even when setting the Paging/Intercom Group as 1-way Paging? [email protected]> wrote:

That?s awesome, Jay! Just scanned through it and it seems to be exactly what i need for starters – this will definitely be my bed-time reading tonight. ? Cheers, Thorsten Von: [email protected]

Do you use the Cisco SG Series switch? i had the same issue with a DMPS3-150 and a Cisco SG350, turning off Auto Negotiation and POE should do it. You could also try to use like a 10-20 Meter

I am also interested in this.? There doesn't appear to be anything available on the ZeeVee website, and the ZIP file included in this thread is encrypted. Anyone have anything for the ZeeVee Zyper

That's how I have it setup.? For testing I have 2 TSW560's, extensions 1001 and 1002.? They can call each other via extension.? If I setup a Paging/Intercom group under Call features of the UCM web

Havent tried it in CH, but I personally have several Eufy cameras that are wifi and they also have a RTSP stream. Maybe CH would find that stream and allow it to be added as a camera? They are like

Thorsten I wrote a detailed article on extension driver development for CH for Residential Tech Today.? You can find the article here:

What I’ve found with the new Apple TV’s is that there’s an option in the menu of the Apple TV to have the “TV” button on the remote take you to the Home Screen (which will have all the

Hi, since KNX-support for CH is available for some time now, i?m considering adding CH to my portfolio. I?ve programmed some custom drivers for IP based devices and am considering to do the same for

CP4 v2.7000.00031.01 As mentioned though, I moved the serial devices to a CP3 slave and it did the same thing...Pretty sure that it's an site-specific electrical anomaly...

Very interest re Auto Neg on the switch. ?Had that once with a Sony display. ? Its was the only way to get the device on the LAN. ? Sony RMA’d the screen and the new one was fine…..Whilst the

What firmware ver is currently on it? 2.5000, 2.6000 or 2.7000? Regards, Stu Typos from my iPhone

Has anyone found a way to launch Debugger with: *Signal Mode: Send All Signals* AND *Have none of the checkboxes checked by default?* The only way to have No signals checked on start seems to require

Thanks, Steve! Very interesting...This is the first time in decades I can remember having this kind of problem... The issue is definitely separate from the processor, here's add'l intel... To clarify

I had the same issue with a DMPS3-4K-150-C. When I turned on the system for the first time I had link lights on the ethernet port. After a while I lost the link lights. After talking with crestron,

You have to create a group of extensions that you want to page in the UCM6202. You cannot call this 'group' from one of the members forming it, so you might need to create multiple groups based on

Sounds like you have some type of latch up issue.? It is quite common for ICs to latch up if there is current flowing into the I/O pins where the input pins are driven by a higher voltage that the