开云体育

I don’t know of such any module that will do everything in one. I use one of the simple ip control modules that is in the marketplace to control most functions. I also use a module that I’ve

Hi Looking to control some Sony Bravia (Android based) but can't find a module that allows full control of it :( I mean control all basics functions including tuner but also recall apps into it. I

Been a little busy so not had time to try this until the other day. ? I found using the SIMPL module there was no volume level feedback from the Sony when the headphone socket is in use. ? Remove

I would verify baud rate settings when in a failed state.? A simple loopback adapter would not show if some bug is causing the com port to change baud.? Since you are reading it with the same port

That "retrieving" the code from the DMPS is a puzzler. Supposedly, all that does is read the "tokens" back from memory. But it must do something else when Toolbox sends the retrieve command. Some

What Phil said is valid, but because serial is reflected in debugger when you use a loopback on the DM-RMC this suggests there may be another problem. Check that you don't have any ground voltage

Usually, a timeout is performed after no user activity on the user interface after a give length of time. Typically a user interface will have buttons that are monitored. It is normally sufficient to

We are having a situation where we don’t have touchpanels in the program. We would like to monitor all the digital, analog and serial signals in the program and if there is inactivity after a fixed

I did one recently with the standard polycom group series module. I noticed that the G7500 seems to be watered down quite a bit.? There quite a bit of functionality missing from the G7500 api.?

Traditionally with DM, loss of control but not content is an IPID issue. Are your end point IPIDs what you expect them to be? -- Cheers Phil

Hi Jason, Where can I download the v2.1 module for Crestron? Best regards.

Assuming that you're talking Touch panels, what Slip said... Right-click on the device symbol header in the program view, and you'll see the extender options for each device...

Check the device extenders available for your touchpanels. Everything there that you need. -s

Is there a built in signal or logic or symbol in SIMPL OR SIMPL+ that can monitor no digital, analog or serial traffic for n seconds and give us a activity timeout. TIA RJ -- Rajiv Jain

Just read on linkedin that there?s a new CH driver for 2N to be released shortly. Von: [email protected] <[email protected]> Im Auftrag von David Chramcow Gesendet: Freitag, 19. November

Thanks Josh! Yeah, I have this with ATSG now...I'll update if/when I learn anything...

I have a problem in a dozen classrooms that crestron has been unable to resolve. wanted to reach out to the Group. DMPS3-4k-350C - DM3 OUT (Shielded Crestron Cat Cable with Crestron Connectors -

We use "unspecified" submodules, and haven't noticed any new problems. -- Josh Winn The LiquidPixel Group

Looking for the best (in terms of integration) solution for adding intercom capabilities to a Crestron Home system. Client wants to hear/see who's at the front door, provide access control through

I am trying to use Jetbrains Rider to build 4-Series Simpl# modules. Has anyone else had issues after building the solution and referencing the CLZ in SImpl+ that it does not import the API or compile