开云体育

Hi All, sorry for the late update. Unfortunately I had the same issues as described by Sébastien LENOIR: no reliable communication. I ended up adding a Skaarhoj TCP ATEM Link device. This thing is

Give us your Software versions list....

Hi Folks, I think I had this before, but cannot remember the root cause/solution. In Toolbox Debugger, the trace shows the state changes, but not the signal names anymore. I did not change anything

Thanks. I thought the console symbol could only be used for the processor and not a connection to the UC Engine? I can see port "41797: Tunnel is ssl: unknown service" is available on the UC Engine, i

Contrary to the suggestions above, I would recommend using the Gather() or GatherAsync() functions for this with CRLF as the delimiter. -- Crestron Service Provider - TBD Enterprises Inc.

Yes. I use it quite frequently, it's part of the Foundation I put into all my programs. I use it on the settings page for a "PROGLOAD -P:ALL, Named "Install Update".? This is so I can load code to

I Believe that shades can have multiple addresses, so you can send a "1","2","3" for individual shade control; "5" for Room Control; and "20" house control. It sounds like your shade has both

Hi, I encountered the same problem this week with a customer with 2 units and the only solution was a restore as well. ?I have had this problem following several power and network outages.

I agree. The Batteries, are very important. DO NOT "Hot Swap" the RF Module, they are fragile.

Has anyone been able to do this? Apparently, you need to write a TLS console connection to the UC which then allows you to send "reboot" via the console (like via Toolbox) This connection needs

Hello tribe, Is there any easy way of getting a simpl controlled third party device into XIO? There is no certified driver for this very make/model but a rather trivial TCP-protocol on port xxx.

You need to search (in a loop) for a string starting with a Space and ending in .mov Then locate the \x0D\x0A delimiter in that new string and remove just the chars after the delimiter which is the

something like Function ParseLine(string line) { filecount = filecount + 1; filenames[filecount] = remove(" ", line); } change rx$ { string line[100]; while(1) { line = remove("\n", rx$);

Thanks for the hints. I tried the raw hex into a discrete serial send so I didn’t have to change much. Took a few different ones but finally got it. I appreciate the assistance.

Hi Maraldi, I had a different issue with that module. I used it last week it was running with the ATEM 1M/E Production Studio 4K. I was able to control the device but it was not that reliable,

Can’t say it was a QB75R but done tons of QB displays via serial. We use a heavily whacked down version of the Crestron module in the DB for an ancient model (400? 460?) mainly because on a certain

Crestronfreak55! good night I tried to use your module but I wasn't successful I changed the ip as mentioned but there is no control over it. the variable initialization$ is in the state =2 but the

Has anyone had luck controlling the Samsung QB75R display with a 232 module? I have tried the 460utn-ud one on the application market with no luck. That same module did work for the UM55H-E displays I

Got it resolved. Had to restore the 4 350's and re-setup. Work fine now, strange issue.

Remove the batteries from the lock, then remove the RF unit from the lock, then, Put it back in and lastly, put the batteries back in. Number 7 option should become available once the lock reboots.