开云体育

But the thing is, the project was installed long back and the problem started recently. So need to check with the client if any new device was installed which is flooding the network. Is there a

I figure I'm doing something foolish but could use some advice.? I run all my interfaces through Control Crosspoints and the Source equipment through Equipment crosspoints (many rooms to many sources

We saw this issue occur in a system where we had 4 Shure MXA910 Dante ceiling mic arrays and a QSC Core110f DSP.? We had to configure IGMP snooping and multicast forwarding on the managed switch port

Like Lincoln said, you have a network issue that has more traffic than CP3 can handle. Usually it is because of a broadcast storm that is caused by a loop in your network.? Common sources of devices

You could comment out any module that looks like it could be causing trouble and load the program. Keep commenting out things until the processor starts without error. Then one-by-one uncomment the

I've had this happen on four DMPS 100s.? I don't have the firmware off the top of my head. I contacted True Blue after the second time, and didn't get a resolution.

But the strange thing is the processor throws the "Data Abort" error along with the thread ID when I try to find it by using the SPLUSTASKS?command I am not getting that? Data Abort's thread ID so

Even I am facing the similar issue "Data Abort" , But the strange thing is the processor throws the "Data Abort" error along with the thread ID when I try to find it by using the SPLUSTASKS?command I

I currently have an Autonomic MMS-1e. Recently I noticed that the coverart isn't displaying on my TPS-6L. It used to work fine but now shows a spinning loading wheel. The strange thing is that the

Ethernet watchdog is virtually always a network issue, specifically broadcast/multicast storms. Do you have AVoIP devices (e.g. NVX, Dante, etc. on the same VLAN)? If so make very sure that IGMP, etc.

Okay, I will put a delay in the program when the system boots up. Thanks for let me know how to debug the data abort error's. I? am not using any XIO cloud and crestron fussion features and I will

Hi Guys, Even I facing the same issue in couple of places, the CP3 errlogs is flooded with watchdog errors. I don't know how to resolve this. When I asked help? from the crestron true blue support

Hi Nick, Even i am facing the same problem now. The CP3 is throwing thousands of error saying ethernet disabled by watchdog. Were you able to find a fix for this? If anyone else knows about the issue,

I received a call from dish integration team earlier this week informing me that they will be pushing out a new beta firmware in a couple of days. I have not seen an improvements in any of my

I've had a rash of processors losing the IP table on a power cycle of the processor in the last couple of months. It's mainly been dmps 250/350's with firmwares 1.08.016 & 2.01.052 and cp3n's with

Yeah I was pretty excited when I tripped over that single IR code. We were in the middle of a pretty large Sonos install when the customer wanted to add local TV sound to a few rooms...it really saved

I?m using WOL successfully on other devices, so i don?t think i?m doing something wrong. I?ve also tried a WOL-tool on my PC which I use for testing – that also doesn?t work reliable. And i?ve

Ok well I think I’m using the UDP client directly to do the WOL and it works. I’ll have a look later and post an update.

I?m using a WOL symbol provided by TB. It works sometimes (so I guess it?s doing the right thing), but not always… The HDMI setting I mentioned in my previous mail didn?t help… I?ll probably

Only works via WOL for me (UK version of the player). Perhaps you’re doing the WOL wrong. How are you doing it?