开云体育

Hello TBB, Do you have any luck on controlling these units via RS232 or LAN? I searched a lots but it seems there is no commands list in their documentation. Regards, Vào Th 3, 23 thg 6, 2020 va?o

I actually found the info about those addresses from a combination of biamp, qsc and shure documentation.? Not much at all from crestron.

Thanks, that makes a lot of sense. Just my luck, searches for unregistered or filtering in the documents I have returned no results.

Thanks for the help guys. I ended up finding a handy python script on github that let me figure out the sudo password. TSW-752>sudo macaddress 0 00.10.7f.xx.xx.xx Username: crengsuperuser Password: *

I had this exact issue using that pakedge switch? a while back.? Ended up buying a Cisco 350x and still had the same problem.? Finally figured it out after a number of headache filled days. Do you

Unofficial way: open it up, extract the SD card, make a image of it, use a HEX editor, replace the deadbeef mac with the correct one, write the image back to the SD card. Or try contact true blue and

Make sure the 352s have a pingable gateway, otherwise you'll see Dante clock issues.

That has been the solution recently as well. I believe Crestron has changed suppliers or manufacture for the NIC Card.

Hello... normally I only install Sony and the control of those are solid. Unfortunately a client wanted a lot of Frame TVs. I'm attempting to control them via IP with a Crestron driver and they work

Clocking is the issue, they will not connect long enough to pass audio. There is no traffic except for the DANTE clock and control. One transmitter, on receiver. NVX stream off.

I had the same problem several months ago with a new classroom install. The advanced replacement from Crestron fixed the issue. It has been rock solid since then. [email protected]> wrote:

What specific issue are you having with Dante? Discovery? Dropouts? Clocking? if it’s discovery then you likely have an issue with broadcast traffic or your controller PC is on a different VLAN. if

Has anyone experienced network issues with the DMPS3-4K-100-C? If I disconnect the network cable then reconnect, I don't get network activity but if I disconnect a second time and reconnect it appears

Don't you think it's a little early to be drinking? Or am I late to the party? With no InfoComm, my body is a little confused right now.

Anyone have a module or has worked with these units ?

Maybe you need use different VLANs to NVX and Dante. You need check if the switch capacity of processing is ok (bandwidth). I think this is not your problem, but, a doble check can help you. Maybe

I am working on? a system using NVX-352 as DANTE sources.There are 15 NVX-352, 14 NVX-D30, and 20 other DANTE devices. I have been trying to get the switches configured correctly. I was able to get

@Julio - email sent. Hope you find it helpful.

Yeah, that joke gets used a lot in testing hardware – it may have just not had the correct MAC programmed in. Not the first time. As long as you don’t have another DEAD BEEF 1234 on the same

I’m sorry… I’m not awake enough and “it was touching itself in weird places” made me laugh a little too hard while drinking this morning… -- Lincoln King-Cliby, CTS, DMC-E-4K/T/D