开云体育

Does simpl# still require some? microsoft framework underneath, that is practically not available anymore ? K.

Hi, I'm having some issues controlling some christie Access series screens over IP. I've been trying the roomview connected display module but get no response from the screens and no feedback, even

OK, cold start of the Yamaha fixed the problem…. Von: [email protected] <[email protected]> Im Auftrag von Thorsten K?hler Gesendet: Montag, 25. Mai 2020 22:52 An: [email protected] Betreff: Re:

Thank you for the suggestions, then I think it's not possible to change room names dynamically and go with the methods you guys suggested.

QB Series is Crestron Connected.? Try that and see if that will work for you.

Justin, Yes you can absolutely use Simpl# to do this. Just use a 3-series intersystems communication to control Simpl Windows if Simpl# doesn't have the equipment you want to control.

Not sure what you are having problems.? What are you using to program the system:? D3PRO, SIMPL, or Crestron Home/Pyng/OS3? Overall I have been pleased with the DIN-CENCN-2 however some of the

Legend.? Thanks for that.? I had seen that and tried but couldnt get it to work but I was just formatting my commands incorrectly. I stupidly assumed that you would be able to set ids like you

Hi, Looking for guidance, thoughts... I'm thinking of rewriting the code for my Home Crestron System and in the process learn to use Simpl#Pro and OOP (I'm a C programmer but I've only dabbled in

In console Help all REPORTCRESNEt 1 or 2 this reports devices attached EX DIN-CENCN-2-POE>REPORTCRESNEt 1 1.11: C2N-IRGWF Wall mount IR gateway:Flush [v1.00.16,#013A23E6] Jul 7 2016 1.12: C2N-IRGWF

Any idea how to change cresnet id's of devices connected to this unit?? There is nothing in the web gui or sys info that I can find that will allow me to change cresnet id's.

Has anyone controlled a Bosch CCU system via IP or RS-232? I am really looking for Mic control and feedback. Thanks

has anyone made this work in simpl??? i haven't seen the? digital or serial joins work from the above code.

To add to the previous answer: if you have time it's worth making up a null modem cable with just TX, RX and Ground and keeping it in your bag, along with some basic gender changers using TX RX and

Definitely try using a cable with only the correct pins connected. Also try flipping pins 2 and 3 (or use a null modem adaptor to try this) e.g. try both 2-2 / 3-3 and 2-3 / 3-2 since I’ve seen the

It does make something like smart graphic extenders in Simpl. That's mainly what it's for, using signal names in Simpl instead of join numbers

but isn't that the point of a template????? Yes i did it with just buttons and used the grid....it works..but i guess i don't understand what the contract editor is for then.? i thought it was to

I'm using a off the shelf straight through cable that ohms out correctly (all 9 pins) and I can't get the projector to respond.? Same program from a ST-CP using a modular connector on one end (6P-6C

Hi Joe. Just to be clear, are you referring to the RTSP stream generated by the TSW from its internal camera? If so, the I think you're correct that the audio from the TSW mic does not get embedded

I wouldn't use a list for keypad buttons, you can't lay them out the way a keypad looks. I've used Grid for mine, that works well as I can lay the keypad out the way I want it to look. You can still