开云体育

In console Help all REPORTCRESNEt 1 or 2 this reports devices attached EX DIN-CENCN-2-POE>REPORTCRESNEt 1 1.11: C2N-IRGWF Wall mount IR gateway:Flush [v1.00.16,#013A23E6] Jul 7 2016 1.12: C2N-IRGWF

Any idea how to change cresnet id's of devices connected to this unit?? There is nothing in the web gui or sys info that I can find that will allow me to change cresnet id's.

Has anyone controlled a Bosch CCU system via IP or RS-232? I am really looking for Mic control and feedback. Thanks

has anyone made this work in simpl??? i haven't seen the? digital or serial joins work from the above code.

To add to the previous answer: if you have time it's worth making up a null modem cable with just TX, RX and Ground and keeping it in your bag, along with some basic gender changers using TX RX and

Definitely try using a cable with only the correct pins connected. Also try flipping pins 2 and 3 (or use a null modem adaptor to try this) e.g. try both 2-2 / 3-3 and 2-3 / 3-2 since I’ve seen the

It does make something like smart graphic extenders in Simpl. That's mainly what it's for, using signal names in Simpl instead of join numbers

but isn't that the point of a template????? Yes i did it with just buttons and used the grid....it works..but i guess i don't understand what the contract editor is for then.? i thought it was to

I'm using a off the shelf straight through cable that ohms out correctly (all 9 pins) and I can't get the projector to respond.? Same program from a ST-CP using a modular connector on one end (6P-6C

Hi Joe. Just to be clear, are you referring to the RTSP stream generated by the TSW from its internal camera? If so, the I think you're correct that the audio from the TSW mic does not get embedded

I wouldn't use a list for keypad buttons, you can't lay them out the way a keypad looks. I've used Grid for mine, that works well as I can lay the keypad out the way I want it to look. You can still

Hi Rob Simply add a "System 3 Reserved Joins" Device Extender to the TSW and use the System Media Mute and System Media Unmute inputs to mute when a SIP call is active and unmute (if you need to?)

Thanks for the response Joe. ?I suspected that was the answer but have been unable to find a way to disable audio at the source. ?I'm using a Grandstream GDS3710 door station which doesn't seem to

Thanks Scott

It has been a minute since I've messed with CH5, but I think the index should just be listed as idx with no number. IE, < ch5-list class = "source-list" indexId = "idx" size = "4" maxWidth = "1000px"

Well, a few days after writing that, i?ve got an issue with a customer who has recently replaced his CA-X5100 with a CA-X5200. Auto feedback is not working anymore after a program update and it?s

Two DIVMODs (one to pull off the hundreds digit, the reminder from that one to get tens/units. ASUM tens, hundreds, and units with 30h to convert the number to its ASCII equivalent (e.g. 30h = ASCII

I am doing a retrofit to update a home with a centralized Crestron Home OS3 setup, and I have replaced the D3-Pro based lighting with Home OS3 control.? ?I am connecting the clx-1dim4, 1dim8,

You should be able to enter setup mode with toolbox.

Scott, The discord is here: https://discord.gg/T5trWkD Once signed in, you'll see the #ch5 forum within. Best, Scott