开云体育

You need to forward both ports 23 and 80 if not using Lutron's connect bridge If you have a Lutron connect bridge, no port forwards are needed

So first off some comments: * Can't connect to it using USB even though the thing has a USB port on the front * Can't find it using Toolbox device discovery on Ethernet (PC & gateway plugged into same

So I'm integrating Crestron with Lutron shades and lighting using IP. All seems we'll but wanted to know if the Lutron processor can be connected remotely. I have forwarded ports on the router so I

Hi Ilya,Did you manage to get the feedback from the LG sorted? Tim

If the LEDs are dimmable, the 2DIM8 is fine. I have a house with over 250 LED loads and using 2DIM8 just fine. I set them up as Incandescent.

Thanks Thanks , Mingo

The CLX-2DIM8 will dim LED's but the driver has to support forward phase dimming. We use CLX-1DIM8's and TCP fixtures in our office, and they play fine. The CLX-2DIMU8 will play with more LEDs as it

3001

I done (successfully) numerous decentralized Crestron lighting control systems but never a centralized. I've been brought in to assess an older installed system from another manufacturer that is

Does anyone know what's the port to use TCP/IP client for the vantage infusion ?

Just a quick note to let people know that I've added a new blog entry to my blog, Topics in Home Automation. The blog entry is titled: Update on Aging in Play with Residential Automation Here is a

I haven’t looked at the pinouts lately, but the Camera DB9 on the MXP codecs could also provide power to a Tandberg camera. Wondering if someone connected oddly wired serial cable to the camera

Not a joke. The magic, factory smoke leaked out of both procs. Per the True Blue support case "Ports fried. Physically saw when it happened; opened CP3N & saw ports smoked"

So, when you say "didn?t bother with others? does that mean you did not test them or that they are not actually making any connection? Using a Crestron 9-pin COM port you must ensure the pins you

Yes, it says file corrupted for me even after re-downloading it.

"The cable I am using is a crossover." It's the same cable as when you test with your PC? "I tried to use serial gather to hold on strings in case it just pass through." If your intent is to hold on

Is the device supposed to reply when you send a command or do you have to query it for its status? If you short pins two and three together at the switch and send a command do you see it come back on

Thanks, It transmitted the command. The switcher at the other end received the command and worked as I told it to do. But I need to know the status of the switcher, because the stupid toggled power

The program is sending commands which is why you see it in debugger. That doesn't mean your wiring is correct. If you want to see if the com port is actually transmitting, tie pin 2 to pin 3 and you

Thanks for the reply. I am using AV2. I am using one of the com port in my C2COM-3 card, and C2COM serial driver. I assumed 2 & 3 are tx and rx. The cable I am using is a crossover. I verified only 2