开云体育

Putting it in the same directory as the project gets it added to the symbol library, but I still don't see it in the device library to assign to a serial port on the Pro2. - Dave

So, what is the most cost effective, reliable way to communicate with a device that takes DMX cues? (CP3 processor) Thanks; Kol

I've used these as replacements for the old 875's. We didn't use the preamp functions or the IP control, just the DSP for setup, and we triggered them on and off. They mostly work well, but I had a

have you guys had any luck with this thing? Im working with this and with appSpace embedded in it. looking for "simple" ch+ ch- controls. thanks, Andrew

So, my AAS-2 shows in the IP table of the AV2 Status OFFLINE. I'm very uncertain about the right settings. Router: 192.168.1.1 AV2: 192.168.1.2 AES: 192.168.1.3 (SIMPL WIN: IPID 20, Default-Address

I suggest trying the wayback machine at archive.org

Does anyone have a copy of the OSC protocol standards? I have a project coming up that leans heavily on this and the website has been down for at least a week now. I've been looking around the net but

"some of the complex logic either takes 30 steps in Simpl or can't be done at all (at least not by me) and I can get it done with 5 lines of S+ code. Those are the circumstances I will revert to S+."

I talked to true blue about this as I wasnt sure if 200 was the max for infinet ex with expanders or if it was max total including wired devices. They told me that 200 was indeed the max for ALL

tcp ip client to port 51325 \xB0\X00\X00\XB0\X20\X00\XC0\X00 preset 1

"This should help explain it. :)" Nope - totally lost now. - Chip

If I remember correctly, the max is 200 devices.

what's the maximum number of wired devices (keypads, DIN RAIL, etc) PYNG can handle?

I found this, it helped with my system when it was taking ages to create a new folder. It may help with this problem?? Unless you want to do a fresh install of Windows then it will clear up some of

Try copying the module to the same folder as your .smw and reload. The notes for the module may be wrong. Can you open the module and check that it is both 2 & 3 series?

What is the limit of IR files on a single IR port? There will only ever be a single IR controlled device on each port but it must be configurable at run time. The scenario is a fully configurable

I need it for a project on a Pro2, but the module is compatible with both 2 and 3-series according to the notes. - Dave

Has the module been configured for both 2 and 3 series processors? Crestron@...> wrote:

I have an old project I'm working on where I need to swap the AVR for a new Anthem serial-controlled model. I have the .umc file and I copied it to the SIMPL/USRMACRO directory, but I can't get it to

Thanks Jason - I didn't realize that was an option and definitely makes it the preferable choice.