开云体育

Use a crossover cable and connect directly to the MP2e. Use Wireshark to find the IP. Type this in the filter for the crestron OUI: eth.src[0:3]==00:10:7F The processor IP should show up from the

Hi All, Is there a way to restore a processor to factory defaults without connecting to tool box (viewport). I've got an MP2e set to static from a previous job, no clue what the IP is and I don't have

I had the same problem a while back, I just set it up as a slave and was done with it.

Upgraded a few days ago.... only one problem with Master Installer running. Anyone else see this problem.?

I'd love to, but since the basis of the code is from the Crestron simpl+ module, I don't think forum rules will allow it - if anyone can confirm this is not the case, then I will gladly post the

I have a module that works a lot better than the Crestron one. It was written by a guy here in Aus. Send me an email at arcprogramming@... and I will send it through.

Lol KAD ;)

How about just using the btn_model_cycledim module that D3 uses?

You could do it with a Press & Hold, Toggle, Analog Ramp, couple LWPs, and a couple Inits if you want toggle on/off and raise. If you want toggle, raise and lower, you'll need to add even more.

Then you've got a bunch of programming to do!

Making it invisible is only for design in VTPro. Sounds like what Phil said, your join must be high. Open debugger and look at the join, if it's high, find out why.

It sounds like your visibility join is high. What does debugger say? [Crestron]" <Crestron@...> wrote:

My problem i that i have already started the lighting programming all in SIMPL windows. I haven't used the D3 program yet.

I already gave it a visibility join to that subpage and all the other subpages and I also made that invisible in the main page. It's also showing on my other touch panel tsw-752 when MC3 reboot or

Thanks, All very helpful. Will have a look for the other thread too. Cheers Brad

Would you mind sharing your edited module with the discrete Home/Away inputs, Mark?

Chip, so you're saying I'm not crazy and I may be on to something? Might be time to update this module.

Commercial guy here, poking the bear! I use crosspoints... sometimes. It's a tool to use when appropriate. I tend to use crosspoints when a combination of digital and serial and/or analog signals are

I have a customer who 'mis-ordered' a TSCW-730, which is a panel/processor all in one, and they intend to use it as a touchpanel only with a DMPS3-300. 1) Should I use EISC in both units, and just

Have you try send WOL magic packet to turn on tv? It is working on new series Sony, and Panasonic tvs. Regards Sent: Thursday, September 03, 2015 3:00 PM To: Crestron@... Subject: RES: