开云体育

Thank you for all the help everyone. These last two examples really helped by moving the abuf or aos, whatever is needed from the interface side to the room side of the x-point. Previously I had it in

not at all. I expect that the thing to do is to embrace CEC. There is a device I just learned about that is basically an IP/serial to CEC converter. Probably a good thing. http://rainshadowtech.com/

Is it bad of me to say that I am pleased to hear that I am not the only one smashing my face into a wall?

Dies anyone have experience using command fusion (simpl plus) from outside of their network. I have a DNS alias with port 8020 forwarded to my mc3, no dice. Thanks, any help would be great! Sent from

I have just wasted over an hour or so trying everything I can find on a UN19D4003 with the same results. Different protocols, different baud 115200 down to 4800, no luck with any of them. I can see a

I would say it is 1 of 2 issues: 1: RS-232 settings are wrong 2: RS-232 pin out wired wrong Female Stero, Plug,(3.5�) Rx 2 ----> 3 Tx Stereo Tx 3 <---- 2 Rx Plug Gnd 5 ----- 5 Gnd (3.5�) Thank you for

I see it go out in debugger, the TV does nothing, and Rx$ is still silent.

Hi Jason, My solution to this (it's buried deep inside our framework, but it's used in lots of places) is to pass each analog value (from the user interaction side) into an AOS, with say a 1 second

They are removing Studio from the class? Many they found out there are too many issue with it. wrote:

Gave it a few minutes of my time to see what it was all about. Haven't used it since.

Use a ground cheater ac "adapter" on the power cord of the PVID. 9 times out of 10 that will work. (using it for the exact opposite of it's intended purpose!)

Just wondering since the big news of it being removed from training etc. Is anyone still using at all for anything? Or everyone has shelved it for now?

Fixed length what OLD SCHOOL From: matt_rasmussen_2000 <mjrtoo@...<mailto:mjrtoo@...>> Reply-To: "Crestron@...<mailto:Crestron@...>"

You're complaining about fixed length delimited strings? How lazy are we getting! :)

I heard once in 1976 they hired Tim(name made up) to do all the protocols for pretty much everyone. Then never changed them again, when checksums and all that other stupid stuff was necessary. I like

Has anyone else been forced to work with the new Middle Atlantic RackLink systems? Where do people come up with these bizarre protocols? 1. Protocol is all hex. 2. You have to generate checksums on

When I switch crosspoints the slider input value which ends up sitting on the output side of the abuf gets sent to the set volume input of my room module. Thanks Heath. That is actually an idea I came

this is power toggle, make sure the TV is on, send it right out Samsung_TX$ in debugger "&#92;x08&#92;x22&#92;x00&#92;x00&#92;x00&#92;x00&#92;xD6" _____ From: Crestron@...

Are you saying that when you switch crosspoints, that the "previous" room's volume feedback sets the volume in the "new" room? Maybe if you pass the press associated with the slider through the

Check Answer ID: 4971 for more details