开云体育

Yes, Neil posted some very nice pics on how it works. I wish I would have had that when I was trying to understand them. Just do a mock program with an xpanel or something and get to testing. Nothing

Hi B That would be great, did you receive my previous email?

I can't really say for the crestron dimmers, but back when I did C4 I had to leave power disconnected to certain dimmers when I was acquiring the others. What I mean is, if you have a 4 story house

Right we've really only needed the swex units for some outdoor loads (if I recal correctly the dimex is rated for 700 or 750W and the swex will do 1000W...

Can you run a wire of the exlink thru a relay that you close, fire your "On" command then open? Etc.

Hi all, I was having the same socket error -1 problem on my CP3. Tried it on my Pro2, and voila it worked. Updated CP3 firmware... voila it worked on that. Apparently CP3 had some funky ethernet

Ken - thank you very much! From: Crestron@... [mailto:Crestron@...] On Behalf Of Ken Brunner Sent: Wednesday, March 20, 2013 4:22 PM To: Crestron@... Subject:

The DIMEX's work fine when set in switch mode, in my experience.

Can you use a non-dimmable load like a florescent light with a CLW-DIMEX-P set in switch mode or do you have to use CLW-SWEX-P?

I have a larger module that supports up to 176 zones, including individual status feedback. Send me an email and I'll reply with it.

Hey Everyone, I just installed my first two Samsung TV's. I recently switched to Samsung from Sharp because I got sick of trying to control the darn things. Anyway, I have an odd scenario going on.

Just a final update... after fighting this thing for almost a month, come to find out it was a bad Netgear gigabit switch.... now I know why I insist on cisco. Have fun, DAVE

I never could find a replacement but I was able to have new cells put into it. We used these guys: http://www.batteryrefill.com/index.phtml

If you have a Batteries Plus around you they can make 1 for you. Pat M From: cheinemann605 <cheinemann@...> Reply-To: <Crestron@...> Date: Wednesday, March 20, 2013 5:03 PM To:

Hey guys, Do you buy your keypad faceplates at Crestron, or do you buy them anywhere else online? Looking for a supplier for both US and international faceplates...

It looks like this for me when I have many pros to load at once: It only took a few minutes to setup 90+ rooms. [7543 Phase III] Connect=tcp CRESTRON-7543-CP3 NVRAMDiskSetSize 64

Any HAI modules available out there besides the Infusebox set? I've looked at Tony's module available from the HAI website, but I need feedback support for more than 96 zones, as well as individual

A week or so ago, we were hung up in a nightmare EX install where none of the EX dimmers or MLX3 would acquire. Wi-spy scans showed lots of not-too-high level interference across the spectrum. I'm

We've installed about a thousand of these and the CLW-SWEX-Ps with great success. They are reliable and fairly durable with most of the features we've needed. The acquisition process is a little

Glue it to the base and... Now it's a hard wired table top panel. Sent from my eMail.