开云体育

Had the same issue, happened upon connecting the poe to it. Was working fine, unplugged it to move it, plugged it back in and buzzzz. Had to send it for repair.

I might be a little late, but how do you know the modules are not compatible, as-is? And if they really aren't, have you tried contacting the module's author?

OK, I have the solution here. By default the remotes for these Bell PVR's are set to UHF (Pro), and to change it over to IR is something they don't care to make obvious, but if you ever run into this

Has anyone worked with a TV One scaler (in this case a C2-2355a) connected via the option cable to an S2-105PCA? If so, can you confirm that if you set the output of the C2 to any RGB input 1) Does it

I am looking for an IR driver for a Bell 9241 PVR, does anyone perhaps have one? The remote says IR/UHF, and my CNXLIR is not able to pick up its signals... Is there a way to get the IR Learner to

I've got a module that'll recall scenes (and provide feedback for same) on a M-400, if that'll help? _____ From: Crestron@... [mailto:Crestron@...] On Behalf Of luckystar Sent:

Hi Marc, We have that device in here in Australia where it's called WattsClever. I wrote a module that parses the stream using nothing but SIMPL. Gather on 47d ("/"). Use an STOA for each XML tag that

As long as your buffer is big enough to accommodate the larger messages, and as long as you're keying your parsing routine to run after seeing a "</msg>" tag, I'm not seeing where there would be a

When/if you find out, let us know. We recently had a project with Mac Mini's on DM distribution. They worked fine for months, and then stopped working. Everything pointed to HDCP key issues. Oddly

Put a Make String Permanent (MSP) on the serial signals on the Equipment side. This will force a refresh on connection.

I am working with cross points and everything works well with the exception of getting my serial data to refresh upon a reconnect. For example I go to my iServer page starting the connection and start

Has anyone experienced problems after doing the latest software updates and then re-compiling older code? Specifically, I'm talking about an issue I've seen recently where it seems like all the joins

I just finished a project where I had an AV2 communicating with two prodigy systems over UDP. I played around with a lot of complicated logic solutions to keep the two in sync, but I eventually found

Do the "Favorites" not do this? I just go the card installed in our showroom system so I haven't had a chance to fully explore the "Favorites" portion. From: Crestron@...

+1 for that. OP

Hello Group, I have an installation with several CEN-IDOCVs installed and several of the devices are emitting loud buzzing sounds from the "brick" (as opposed to the "puck"). One of my techs contacted

Hey, We are trying to extract the URL for the current playing station so that we save it and recall it as a simple preset. I know you could probably rig up some steppers to recall favorites, but this

Why not monitor the status of the IP connection (offline manager, output of a TCP Client, etc. . .) and (re)send the update command on the appropriate edge of the status digital? _____ From:

digging up an old one here - does anyone have a module or code chunk they wouldn't mind sharing for a Roland M-300 mixing console? We're going to do RS-232 control. The thread below mentions some

Chris, thanks a bunch. In your implementation, did you account for the processors going off line, or id your only update the XSIGs on boot. Just wondering...cause maybe in reality that will cover me