开云体育

Uploaded to file section as BenQ W5000+W20000 Cable+RS232 Proto.zip

Hi guys, managed to get all the commands working for controlling my Dune HD Smart D1 thanks to the inputs you guys gave here. Got a question about feedback from the Dune device itself - is there any

That's a good deal, even cheaper then when using CAIP discount. CAIPs are explicitly forbidden from also being a dealer though, otherwise I might jump at that.

Open up the Argument Definition symbol in your module, then either highlight and hit Alt-F3 or right click on it and select "Edit Parameter Properties". One of the options in the dialog that comes up

Can't wait for D3 to reach 3.0 level !

You may find that this question and any other module related questions can be answered by opening an instance of SIMPL, set it up as a module then click on the ArgumentDefinition in program view then

Ahh, there lies the rub. Having been following the posts recently re 3.01.22.00 I'm a bit loath to upgrade just yet. We are trying to maintain similar stable environments on all our machines so I may

I want to create a module in Simpl, which contains an analog initialize feeding into an analog equate. I want the module to have a parameter field, so that I can for example in parameter field 1,

Thanks for that link. Yes two way traffic was an issue with Cartell and looks like Renoae has a solution for it. No work around.

Square D has a 120v coil DPDT 30 Amp relay with device mounting box that I use on exterior in ground lighting to isolate the switch from the lighting. Around $85.00. Ross

No problem to control the switch, i will check for a relay who can do the jobs. I have use in the past a box who control the light because the load use exceed the maximum value of the clW switch. I

It is a single phase, hot to ground on a 600V Y system! Much like 277 is hot to ground on a 480 Y system here. Cool. >

I would imagine you can use a 120V coil relay to to that (as long as the switched voltage rating is sufficient. Mount the relay in a J-Box near the dimmer. Are you able to power the 120V CLW properly?

Relay or contactor, either with a 120v coil. Chris [Non-text portions of this message have been removed]

What you require is called a three phase "contactor" with a 120 volt coil. ?I am assuming that 347 volts is three phase, I not familiar with your power system in Canada. the American company Square D

Any suggestion. I want to trig 347 light with 120. Volt clw-sw Thanks for help Rapha?l Thiffault Programmeur Intégrations Duocom Canada 10000, Boul. Cavendish St-Laurent, Qc H4M 2V1 Message envoyé

I just had the same problem. You need to update your SIMPL as well. I updated both the Crestron DB and the Device DB but did not update SIMPL and got the exact same error. Updated SIMPL to 3.01.22.00

Over on AVS, there was discussion that the W5000 was being rebadged as a Sim2 D60. Try that protocol, serial specs, pinout. Chris

So did we, before we switched to Rena A&E. Cartell's box is larger, and you'd need to custom wire 2 of them (and call them to get the wiring diagram) in order to do directional logic. We've been much

Try these guys - http://www.cartell.com/ - I have used them before without any issues. There is extra set of relays, either NO or NC where you can program an event after vehicle detection. Tom