开云体育

Thank you, I did see that. But on reboot, how can you tell program 2 not to start?

I had skimmed the file you linked, but hadn't looked closely enough.? After reading through it again, that does seem like the way it's got to get done.? Now to make it work. Thanks, Paul

Hmm, so you came back and it was not working anymore. Or did you recompile the UI and upload a new compiled UI? The only thing which comes to my mind is, that there is an issue wie compiling the UI

I've been working on ch5 for a while. ?I had a number of pages and widgets working with my control system using the Contract Editor. Everything was fine up until Saturday 1st March. Deployment was on

Good day I faced a strange issue with UDP listener between 3 and 4 series processor. I need to listen mDNS stream for a specific address (in my case 192.xxx.xxx.036). I made a test program on RMC4 -

I've tried to delete SPLs e.t.c. Until "ReCompile ALL" it didn't work. More over, after the first pressing Recompile all, I got an info that I have lots of errors in SIMPL project. F.e. It found some

what name a module sir, i need the module right now, i can't found in application market

Look in the device extenders for the processor. ?System Monitor>System Control

Hey All, I have 3 programs on my processor, how can I control when one is started vs the other? For example: On system reboot, I don't want program 2 to start until I tell it to. Thanks

I know I can loop over an AddressList of device hostnames/IP addresses, but I would like to dynamically set a hostname or IP-ID according to the device. This didn't work for me, but I can't help but

Don't forget to go to iPhone Settings, Scroll way down to your apps list and find CrestronGo, and enable "Allow CrestronGo to Access: Local Network" If you are connecting over Cell enable Cellular

I think the regular compile just doesn't recompile the modules if the SPLwork folder has a previously compiled version in it. That's one of the reasons why I always use Recompile All. I'm sure it adds

FTR, the OP said that his issue was with an iPhone....

Were you able to figure out what remote codes worked with the evolution boxes?? I have 11 going into a system.

It does work when ran through VT-Pro and Toolbox does show its connected to the correct IP ID. The Samsung phone is using local wi-fi and the IP address is on the same subnet as the Crestron

Has anyone done this?? The API says Ascii, Hex, Base64, RTF8 with a 128 character limit.? All the commands I have are pronto hex. For testing, I'm using known working TV commands for a sharp I have

I have a client that got the latest SAMSUNG smartphone (S25 Ultra I believe), and for the life of me I couldn't get it to connect with that phone, every other phone in the house (wife, kids, etc)

I would run the Crestron Go file in VTPro-e and see if you can get it to connect. I'd also see if you can "see" the app in toolbox when you have the app open, if so transfer the project file to the

" click 'Recompile ALL'." Many thanks - that works!! I'm still wondering what happens with regular compile. but I can work !

I didn't see an affirmation that the phone and processor are on the same subnet. If they are not, and you don't have correct gateway set on the processor, it will be exact same situation (you will see