开云体育

What audio matrix are you currently using to distribute the existing Radio tuners?? or are they just 'hard-coded' in a one-to-one relationship with the zones. If you already have some type of

Hi All, Appreciate all the responses and help. Just thought I would close this off as it seems we have solved the issue. On Friday I did a span of one of the problem ports, analysing it in wireshark I

it appears to load the project into portrait mode as the panel boots, i see the crestron logo large, then smaller, then it flips to portrait with the crestron logo with the dots below so even the

Thanks, Jay. Agreed!! MQSACK, That's a good suggestion, however it is similar to Crestron Din unit. What I'm really looking for is an integratable Hi-Voltage wall mount TStat that can replace an

Try initialize, followed by restore.

LCDORIENTATION says updating to landscape, reboot, still portrait however, setting it to portrait set it back to landscape... well, the ch5 project was fine, however, now it thinks it is a TSW-770P

CoolAutomation GS-SMT-HOA is another option. High voltage relays right on board. https://coolautomation.com/other-hvac-control-devices/underfloor-heating-controller/ 2022 CoolAutomation

Yopu could try these where the IP of course need to be changed :) Auto Tracking OFF: http://192.168.0.10/cgi-bin/aw_cam?cmd=OSL:B6:0&res=1 Auto Tracking ON:

Did you have a 1080 defined in your SIMPL program? This has a device extender to set it to portrait/landscape. Most likely that messed up the 770

No arguments on anything you are saying.? Unless you are a programmer, looking to automate existing shades on a budget that fits your salary, you are not going to to use SwitchBot products for shade

My concern isn't margin (though we all love Crestron margins!!), it's that many of these products are 'consumer' in design philosophy that makes integration difficult to wilderness experiences

I have a customer with a small residential distributed music system (CP3N, programmed in SIMPL) with several AM-FM radios as selectable inputs. I am looking at alternatives to off-air AM, as the

Try the console command 'LCDORIENTATION'

Have you confirmed the correct subnet mask and default route on the processors? If your single user VPN gets an address on the same subnet as the devices there is no routing (at least as far as the

i loaded a construct project for a 1080 into my 770, the TP switched to portrait mode i reloaded my original project - still portrait haven't found a way to set it back?? reloading firmware did NOT

Good Morning, I am controlling a Panasonic AW-UE50KPJ? using the module Panasonic_PTZ_Camera_Series-HE-UE-UB-HR through IP. I do need the command to start/stop the autotracking. Any help?? Thanks a

My bet is the IP range in your office is the same as on the control subnet of the processors, IIRC that's by default 172.22.0.0/24. You can change the IP range on the processors through toolbox in the

The only difference we can see between the two is that the single user VPN, my computer receives an IP address on the customers network while on the site-to-site VPN, my computer keeps its IP on our

My guess is you forgot to put the default gateway or have it wrong on those processors.

Hello, I have a site with two 4 series processors, one CP4n and one Zum-Hub4. Both devices have SSL enabled. One TSW-770 connects to both devices and this device also has SSL enabled. On-site, I can