开云体育

This is going to require some drywall work, RTI panels has a large cutout and use wings and screws to mount them vs the mounting bracket style crestron uses.

Have had a few. The card has to be flashed while in the processor. I've tried but so far, can't be done. TB will just tell you to send it in. Be careful as the SD card is not formatted so your

There is a working example of matrix mixer crosspoint control in the example program from the application market.

All sorted, thank you Tony you are a star :)

I remember trying to control an Epipan VGA Grid via IP and it was quite the hassle. Similar protocol from what I can tell. I ended up using an Extron IP to serial box and controlling it via the 232

Hi folks, I picked up a used DMPS-300-C to put in our Fellowship Hall at church, just using the OOB program and front panel currently (hopefully a 2nd hand touchscreen later). Anyway, I've been

The 76 controls are for 4 Biamp Audia units connected through Cobranet. We only use the level controls and the on/off (mute) controls.

After thinking about it some more, the issue with RCON to the cresnet port is that no ID was defined. Prolly the right command to use for this is PASSTO… Caleb Radecky | Manager, Online Products &

Hi everybody! I`m new here I hope you can help me. I have serveral PMC3 with corrupted SD cards, I took 3 of them to rma and there is when I found out they had an SD inside. I figured that replacing a

RCON is a supported command on some NON-DM devices as well. Not sure if it's supported on the DAP8, but I just wanted to make sure you understood that it is not only supported by the DM chassis.

It's been a while since I peeked inside of mine, but doesn't the DAP8 have a coin battery for saving settings?

Thats a fair point, I assumed the RCON was more of a one-shot PASSTO command. I know theres an old command that can shoot off cresnet packets- but sadly not a great deal of documentation on it either.

Yes, this is just for startup. How many in each group.

This code below in an SIO works great for powering on a Barco F90-4K {"jsonrpc": "2.0", "method": "system.poweron", "params": {}, "id": 21} David

Meridian contracted some of the guys from this group to write one and it is working well. I would contact your Meridian/Barco rep to get access to the module. I'm not sure if I'm allowed to share it

"I have a program with 76 Biamp controls. Could I poll all controls at once or should I use a delay and poll each control separately?" That's a lot for an Audia platform! I would use steppers to poll

"Was hoping someone has mucked through this already. Any help would be greatly appreciated." You said in your post "This string does start the recording and is confirmed to work.", but I don't know if

Index one for Input channel and Index 2 for Output channel Sent from my Bell Samsung device over Canada's largest network.

Hi Heather, Have you succeed looking for a right module for you need? I'm having the same problem. Please, if there is one, let me know where to get it. Gennadii Integration Engineer IMS Group, Saint

Hello, can someone help me how to control the Matrix mixer of tesira? I only need to control the state. I dont know how does the index 1 and 2 work on the module. Thanks!