开云体育

Blow it out

Ok, thanks, I missed that in the spec sheet. What are we supposed to do with the Pre-Loaded "AVFramework" program that's loaded in these things. If doing a custom project, should we blow it out with

Or put your DPAD signals (up, down, left, right) into a NOR and drive the STOP command from the output. As long as the STOP logic is only edge triggered, there's no need for any additional pulse

Got it - I hadn't published my SmartApp which was causing the error. Thanks for your help!

Does anyone have a module that works with the polycom HDX 8000 global address book? The crestron module version 3.5 that is in the application market doesn't seem to work right. The navigation of the

Hi Rick Yes a port forward is required. The port is then added as one of the parameters in the receiver module. It also must be put in the groovy code with the public IP address of your router. Look

Hi Jay Did you need to setup any NAT port forwards from your external router to your SmartThings hub? Cheers, Rick

Complete details here: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=302199750497 http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=302199750497 Feel free to contact me directly with any

Use a LWP instead of a one-shot. If there isn't a need for an actual time based operation, a one-shot introduces extra overhead that's not usually needed. [Crestron] <Crestron@...> wrote:

Button press to the [TRIG*] of a One Shot. 0 on the Trig. The OUT will pulse when you release the DPAD Crestron@...> wrote:

I am controlling a Huddle USB Camera that requires a stop command be sent after PZT actions and I am looking for suggestions as to how best to implement the STOP command after a button release. I am

Have many custom animations for SG, fountain, garage doors, ceiling fans. When you're editing your theme in Studio, add your animations.

And how are you getting the MAC addresses per port on the DM frame? Inquiring minds want to know... [Crestron] <Crestron@...> wrote:

Each program is confined to it's slot, so if you have a copy of the module in slot 1, it's events and callbacks won't show up on the same module/program running in slot 2. If your class isn't static

We have done this a few time recently in hospital operating theatres where by they have portable medical equipment that can be used in any theatre. We wrote a mac address module that allowed the

I have been googling off and on for the past couple months trying to figure out how to add custom Animated Objects to my touch panels. The only one i have currently is the Spinner but was hoping there

I'm trying to get my head around the basics of SIMPl# at the moment. If I have the same SIMPl+ module on multiple programs will the function callbacks from the same SIMPl# library cause conflicts? If

I have never seen that specific issue. However, unfortunately, the initial setup of the code is a bit complex and convoluted. I have been meaning to write a document that describes the procedure to

Did you have any issues with the initial setup? I got an error when I tried to authorise my Crestron processor on the web page - I copied/pasted the URL from Toolbox and selected my 'Hone' hub from

If you were to look at it with WireShark, you would see the other items that are added on by the browser that isn't readily apparent from the link you are using. For a different make camera, the API