开云体育

Check your pinouts. If you're using one of the newer 3 series processors, some people have trouble with pinning them correctly because they aren't used to having RX and TX labeled for them. When in

Seems that the issue with the reel is the slip ring that allow the reel to turn causes too much return loss when testing with a Fluke cable tester. The vendor said that they test with a ByteBrothers

Thanx Mate Let me check my system, if it works

That's a good point about stranded. If it's not too late, you may do better with a fiber reel especially under extended/repeated use.

Is the cable on the retractable reel stranded or solid core? Solid core would certainly be susceptible to issues with reeling and I reeling so strafed would be better but stranded has issues over long

I've successfully used spools of Liberty Cat6 to simulate a distance run when testing out a rack, so I don't think there's anything inherent in a spool that would cause data loss. If you're constantly

Not sure if this was addressed to me, but I'm using the Roku3 module that uses direct sockets. (Roku3_archive) Crestron@...> wrote:

Your not alone. I have this issue as well on scrolling list and also all sub pages are shifted to the left even though left is not checked off in the Anchor settings.

Not sure if it's this reel or all reels trying to pass DM. Hoping someone had used one successfully. lincoln@... [Crestron] <Crestron@...> wrote:

Sounds like you have a dud of a real reel then… -- Lincoln King-Cliby, CTS, DMC-E-4K/T/D Commercial Market Director Sr. Systems Architect | Crestron Certified Master Programmer (Gold) ControlWorks

Hi Phil, Did you set the TCP/IP client port to 8060?

We had our networking group test this reel and it comes back with a failure for return loss. The rest of the cable path tests good. [Crestron] <Crestron@...> wrote:

The problem with using NO is it's (even less) fail safe. NC/Normally closed should be used because if the wire is cut/broken/burned through/etc. the system will default to the "safe" state of audio

No one else had this? Really? Just me then....so I suppose it must be something I've not done right!

Use NO (Normally open) and Common wired into an I/O. When the Input closes, mute the system, and lock out any TP controls. Just as if it were a button. When it opens, unmute and remove panel lockout,

Connect a line from the NC (normally closed) and ground terminal to an IO port on the Crestron. In your programming, the signal on that input will be high until the relay opens. Use a one shot with

Hi guys Anybody by any chance got a driver for the ATN 1000 satellite box? Its an Arabsat receiver. Cheers!

I had this issue a while ago, I needed to open the IR file that I made in toolbox in Deal and save it again using Deal. Once I saved it in Deal it showed up in my database.

Hi I got a Fire Interface from Building Fire Panel which got NO, NC, and Com, I need a sample module to Mute the system Volume if fire triggers, By using IO Ports in AV3 Processor, Could someone help

Hi I've used the my.crestron.com as a DNS client for a vpn . Then used the draytek modems as a the vpn gateway . It's so simple to set up that any non network savvy person should be able to do it .