开云体育

Hmmm... Has a nice ring to it... - Chip

Chips House of Masterful Programming and Integrated Technologies - ChompIT for short. Sent from my eMail.

Yes, worked fine for 2 months then issues.. Master IP entry for my slave looks like this: 65 192.168.001.079 slave 00 41794 cip online OP

Does a Mac xPanel suffer from this as well?

Do you know if menu 1999 work to go to the factory menu to reset the rs232 port.

Good one... ;)

RS232 by definition doesn't support anything beyond 5 wires max for RX, TX, GND, CTS & RTS. I have seen all kinda of issues with NEC E series displays bing VERY picky about the peak voltage the

Yes, this works with a full 9-pin cable using a full DB9 com port. But as anyone been able to control these with the usual 2,3,5? The monitor has a 4-position 2.5mm jack, with a supplied 2.5mm -

Not old and cranky Heath, Just "well seasoned and spicy" ;)

are you guys setting the ip tables right? When you have a 2 series slave (whether the master is 2 or 3 series), the IPT in the master must have the IP Address of the slave. If the slave is 2 series,

Nope, it was not done. Perhaps OP had an old xpanel that they recompiled and it dragged in all the xpanel 64 bit stuff too, that makes things much bigger and causes fitting problems.

I'm running a custom theme I built from scratch. Problem could be that the theme wasn't compiled after the app was released. Try importing the theme into studio and (latest version) compile and

Glad it worked!

Awesome! That saved me a ton to head-aches. I'd never even noticed that option before.... <btrujillo4343@...> wrote:

I have one you can have but you will need a new case/latch. It works great but the battery won't latch

Did you try "Recompute Signal Types" in the Project menu?

I'm editing a module, and somehow SIMPL has decided that the [~UNUSED~] signals on the DEFARGS should be an analog signal (highlighted red). Saving the module gives the "Problem Saving Program

We had a project where we ran OM2 fiber and used 8G DM hardware and it worked out just fine, I think it was our first DM system (back when we were told by Crestron that OM2 was fine, and they later

I have to say I feel your pain. Having been tarnished with many Crestron-product-that-didn't-perform-as-advertised brushes (i.e. TPMC10, Adagio, early DM, MC3 (Video GUI), TPMC9, TSW750, etc.)when

I have a few things that I'd like to get rid of: - AMS-AIP with dual-AM/FM tuner card. Somewhat ugly shipping box (from AVAD). Clean unit. Has been sitting in the bottom of my desk rack for way