开云体育

Does the projector state it can scan that high of a resolution? If not,you would need to use a scaling receiver like the scaler-c and set it to the projectors native resolution.

Hi, We have a project coming up where the client would like to control 170 Philips 2K12 (22HFL4007D/10 - 42HFL4007D/10) TVs via Ethernet. Has anyone done this or have access to a protocol? I believe

What are the alternative to Crestron for full HD distribution, when the budget is tight? 4x4, 8x8 or 16x16 tx

anyone worked with roomview sheduling? any gui ?

I must say that Airplay is great, but it doesn't always work. It will stop working for no apparent reason like weddellkw described. At first it seemed to me like the Airplay was the "once for all"

I take issue with only one thing in this video. The gentleman states that Ruckus' beamforming feature isn't "fair" so they put the WAP in a different room to remove the feature. While I understand

Actually, There was a database release that had an include.dat that caused 3.155 firmware to continually reboot Harvey

I have a 1080 source runninig via DMPS 300 C Dm out to DM-RMC-100 C to 1280 x 800 projector, no issues and projector model is detected. when I connect same manufacturer 1920 x 1200 I get no device

There is a thread a while back about this. You need to look at the cameras API and set the URL to request the stream from the camera at the size and frame rate you want. Axis has alot of documentation

Works fine and you can tweak it with the procise tool. It will just flash the warning on the screen that you haven't calibrated it and to contact your dealer until you do.

Same as the nvs using jpeg file with 15 refresh ** Has anyone been successful viewing H.264 streaming video directly from an Axis camera to the TSW750? In theory, the 750 is supposed to support H.264,

PS: Have Ubiquiti on a Vessel with 5 AP's and the manager software running on a PC, 4 of the AP's were on channel 6 my IT Guy informed me and the last AP on channel 1. The managing Software have the

Perhaps this Video will help you decide or at least shine some light... http://www.youtube.com/watch?v=uxmSh87KOIc ________________________________ To: Crestron@... Sent: Tuesday, May 7,

Does anyone know of a way to use Procise without ever setting up or using the Audyssey calibration? -- OR is there a way to load a blank file (assuming I can get one) on the processor using the

D'oh - you're right... - Chip

I think you're both right. I've had several processors get in that loop or refuse to take a program because FW and DB weren't lined up. Heath Volmer Digital Domain Systems Littleton, CO Sent from my

Actually, it's the reverse. If you update the firmware without recompiling the program with the newer databases then you get the problem.

Any chance the firmware in the unit is kinda on the old side? A few database versions back I found that newly compiled programs would stop working in processors they had been fine in until the

I have had this problem on the older units before they upgraded the amount of memory that was in them. They would work perfectly up until a certain point and then what's the program got too large with

This usually happens when the Pro2 can't detect it's IO and/or COM boards. Given that they're sandwiched between the backplane and the case, I doubt they came loose, but you might as well check. Might