开云体育

No arguments on anything you are saying.? Unless you are a programmer, looking to automate existing shades on a budget that fits your salary, you are not going to to use SwitchBot products for shade

My concern isn't margin (though we all love Crestron margins!!), it's that many of these products are 'consumer' in design philosophy that makes integration difficult to wilderness experiences

I have a customer with a small residential distributed music system (CP3N, programmed in SIMPL) with several AM-FM radios as selectable inputs. I am looking at alternatives to off-air AM, as the

Try the console command 'LCDORIENTATION'

Have you confirmed the correct subnet mask and default route on the processors? If your single user VPN gets an address on the same subnet as the devices there is no routing (at least as far as the

i loaded a construct project for a 1080 into my 770, the TP switched to portrait mode i reloaded my original project - still portrait haven't found a way to set it back?? reloading firmware did NOT

Good Morning, I am controlling a Panasonic AW-UE50KPJ? using the module Panasonic_PTZ_Camera_Series-HE-UE-UB-HR through IP. I do need the command to start/stop the autotracking. Any help?? Thanks a

My bet is the IP range in your office is the same as on the control subnet of the processors, IIRC that's by default 172.22.0.0/24. You can change the IP range on the processors through toolbox in the

The only difference we can see between the two is that the single user VPN, my computer receives an IP address on the customers network while on the site-to-site VPN, my computer keeps its IP on our

My guess is you forgot to put the default gateway or have it wrong on those processors.

Hello, I have a site with two 4 series processors, one CP4n and one Zum-Hub4. Both devices have SSL enabled. One TSW-770 connects to both devices and this device also has SSL enabled. On-site, I can

See they are going to take our jobs lol. I recently had the opposite problem. I had a variable that I was using globally that was causing issues and needed to be local. :) Skynet solved the problem

change "isProcessing" local variable to a global variable and added a Debounce to the input trigger. So far seems to be working.

Ai overloads says: The issue lies in your change Console_Rx$ handler logic where the isProcessing variable is used. In its current state, isProcessing is declared as a local variable in the change

the following Simp+ code is intended to set flags and send a command to console to retrieve data. During the "change Console_Rx$" I have placed several flags to prevent if already processing data,

Looks like he is on LinkedIn. [email protected]> wrote:

Hello, i am looking for a programmer going by Ben Street name, for a Restaurant job he did in Miami FL, if anybody knows him please reach out. Thanks

Thanks Chris. I've just been a firm believer for a long time that there are great IoT devices out there, that have some incredible functionality, and can really enhance a smart home.? And, Just

As always, Thanks to Brian and Jay... I hope that we can do some testing for a good floor heat TStat and find a decent solution for these kinds of things. Hubitat and Home Assistant increasingly seem

Hi!? ?I had a similar circumstance.? ?It turned out that I needed to turn of spanning tree protocol on all NVX ports and the problem was gone.