开云体育

Hi, Yes, but depend on what you want to do ...

Hi, Did anyone successfully completed crestron with canbus system. How to send canbus commands through serial, i mean the command structure. I couldn't find any helpful file regarding this canbus

Off the top of my head. I wonder if you could use an SIO attached to the Fusion serial symbol. Drive SIO digital's with button options showing issues. Match your SIO serial strings with those button

This answer is correct and is what i misssed, The name I has in the subslot was different. Thanks for the input I got it working now

i just found it this week if you hit mute, then vol-, the volume goes to 100% it seems that HE doesn't restore the original vol before decrementing mute sets the vol to 0, vol- goes to -1 i wrote some

Did you remember to specify the Project Name (VTProE filename, minus the .vtp extension) in the Crestron App subslot in SIMPL? That parameter informs the processor which file on the webserver is to be

Just following up on this thread - Bill concluded there were no issues. The command was just accidentally being sent on RX$ instead of TX$ during testing.

Hi I have just tried making an image from on of mTSWy 760’s to repair another panel of mine l that has failed, assuming it is the SD card. ?On trying to make an image from the SD card I am getting

Folks - I am trying to allow a Touch Panel user to select single or several messages based on help desk issues they are experiencing, then send that to Fusion/email. I am having issues building

FYI for everyone here. Crestron's response. Answer ID - 1001829 Pretty much what Marc said.

The following files and folders have been uploaded to the Files area of the [email protected] group. * /ESI-Draper Intelliflex Docs.zip (

Upon further checking the Draper Intelliflex documentation may be what you are looking for. The interface pictures that you sent the link to is the ESI (Draper) SC1. These in fact use a local control

I believe so. After working with Sony yesterday, I can turn the projector on, but not off. Nor can I change inputs. However, I get 'ok' and proper responses for input and power state queries. I will

I believe that those interfaces were made by ESI and used by both Draper Shade as well as Somfy. These can be controlled via RS-232 using either an RS232 port or using one of the IR ports set as a

Hi, Can you upload the IR driver that partially works to the files section of this forum? Maybe we can investigate and create additional commands Best regards Crestronfreak55

Somfy's tech support should be able to confirm whether or not they're actually Somfy parts. If so, they should also be able to provide or help find the correct driver.

The only IR drivers I've found anywhere (Crestron DB, RemoteCentral, GlobalCache) are the same 3 drivers and none of these control the shades I'm dealing with. It's possible the shades or the IR

Thanks Marc, I am headed back to my customer's office to give it another try.

So far we've been having success with the latest guidance of turning off Zoom Room Page Flip, letting the panel cycle through a reboot, verifying Zoom 5.13.0 gets installed via the Status page, then

i need one too